Can i run power cables through any of these??

[conradl 0]

I have a 2007 honda accord and i am planning on doing my first amp installation, and i'm wondering if any of these outlets will be able to get through the firewall. if so how would i get it through?? do i just take the plug off, or do i cut through it?

Edited May 19, 2007 by Jorge

[Godsmack 361]

The third plug should work just fine........double check on the inside part of the firewall that it won't run into anything major and you should be fine. Personally i just punchthrough it with a small drill bit and push the wire through into the engine bay. Make a more water tight fit.

J

[bdawson72 0]

I'm really surprised that there arent any grommets anywhere.

[bdawson72 0]

besides the ones shown that is

[Godsmack 361]

Hence the suggestion of using the 3rd one......

[Tirefryr 1,742]

Second one is a panel clip only. Third looks to be the same too, but could be a hole plug. See if it is removeable, but like Jordan said, make sure there's nothing behind it getting in the way.

[conradl 0]

Second one is a panel clip only. Third looks to be the same too, but could be a hole plug. See if it is removeable, but like Jordan said, make sure there's nothing behind it getting in the way.

thanks i will do that pretty soon

[Godsmack 361]

I know i had a similar looking one to the 3rd on in my 99 Explorer.

Had the hitch kit ran through it so i just shoved the 4 awg through there.

It was made ofrubber so it helped keep the elements out too.

J

[Aaron Clinton 2,372]

I had to use the Dremel to get the 4/0 on the explorer.

[X-OvrDistortion 0]

My truck has a 5" plastic thingy on it. It looked as though someone drilled a hole through it for another wire (not there anymore), so I just used that. That was about the only easy thing in the install of this damn system.

I would also use the top one. My 96 Accord was set up that same way.