Aura motor re-cone?

[Cadre 0]

Is there any possible chance that I could get a re-cone (and basket) for a 3" Aurasound NRT motor?

Internal diameter is 3.185"

External diameter is 3.254"

Depth is 2.380"

Bolt pattern is 6 x 4.912" on center

Back

Face

[Tremor1127 0]

wow, thats an awesome motor assembly, do you have any links to the actual driver? and its brass too, eh?

[Tremor1127 0]

and do you have a shot from just the side?

[Cadre 0]

Sure, here is what the orginal looks like.

But here is it's big brother, 4" motor

They are actually very good motors, no stray magnetic flux; all is focused on the VC.

Last pic, this is the only 15" NRT like it that I've ever seen, or that the company would acknowledge that exists.

[bdawson72 0]

Now that actually is interesting

[NDMstang65 403]

The ID is the width of the pole piece?

If so i know we can't do it..coil will rub out, not to mention i don't think any stock coils will fit that itty bitty gap anyhow .

[Cadre 0]

The ID is the width of the pole piece?

If so i know we can't do it..coil will rub out, not to mention i don't think any stock coils will fit that itty bitty gap anyhow .

Thanks for the prompt reply. I knew it would be tough but I thought I'd ask just to see.

[NDMstang65 403]

I'll wait for scott to give the definitive answer, but i'm fairly certain that we don't have anything that'l fit.

I think they use a very small 2 layer voice coil..the smallest we have is a 4 layer