low beam headlight issue

[Shogen 325]

Sooo... my hid lights failed because of a cheap relay that came with the set. Put some basic bulbs in and one side doesn't work. I try the fuse, get power at the fuse. I check the socket, get power at the Socket. I move the non working bulb to the other side, it's work. I try replacing socket connector thinking maybe bad corroded tips not making great connection to bulb.. same result... Wth is going on???

Any help would be great...!

[Dangrebel 89]

If you swap working bulb into non working socket what does it do?

[///M5 2,833]

If you swap working bulb into non working socket what does it do?

Doesn't work.

Obviously either you got a new bum socket, wired it wrong, or have a problem up stream from the socket. Not sure where you tested it, but it would be after that.

*realize it seems so straightforward it is dumbfounding and once you figure out what it is I'll bet it was dumb too. Always the hardest shit to find.

[Shogen 325]

Lol. M5... That's how I feel right now.. I measured voltage at wire without socket and with socket, same result... 12.7-.8

Dang, I didn't try the other bulb in this socket. Also, found an issue with my front battery, some building going on.. might need to repave even though it reads fine

[Dangrebel 89]

I had this problem once. The wire was broken online somewhere, it would pass enough current to read but then when you hook up a source the voltage would drop to 1 volt because of the resistance. Check wires, you may just have to run a relay kit for your low beams if you can't fine the issue.