Jump to content
Sign in to follow this  
kuykendall54

Electrical for SAZ 2500

Recommended Posts

Looking to buy a saz 2500 and just seeing what you guys think i should do about electrical to power the amp. It'll be pushing a sp4 reconed by psi audio, they told me that it will be 2500 rms or better. ill be running the amp at .5 ohm. For electrical so far i have the big 3, a 350 amp alternator by bnr parts (junk by the way) looking for a 270 amp alt by mechman and a xs power d3400 under the hood with all 1/0 gauge. Just trying to get some help with what i should upgrade to run .5 ohms daily. looking to get dual toolmarker 1/0 for the power and ground for 2 runs of 1/0 wire. should i be looking at another battery? and what if i got just a smaller battery and put the 3400 in the back? Any help is greatly appreciated.

Share this post


Link to post
Share on other sites

You are looking at 250 amps of draw so a good alternator and an extra battery should be sufficient. 

Share this post


Link to post
Share on other sites

dont run it at .5

Share this post


Link to post
Share on other sites

dont run it at .5

Yes I would also advise against running it at .5 simply because it isn't covered under warranty if it shits out which is very likely if you push it too far.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×