Jump to content

Recommended Posts

I know it depends on the vehicle or whatever but , would a power acoustik bamf amp 5500d power two 15" Fi SSDs better then a hifonics brutus 1200.1d ?

i have the Hifonics amp now and it hits but now as hard as when it was hooked up to one 15.

Yes i know power acoustik is not that great.

Share this post


Link to post
Share on other sites

I dont know why you keep making threads asking about shitty amps....

If buying shitty equipment just use simple math and go for it. SSD's are rated at 1000 rms each x 2 subs = 2000rms. Now find a amp rated at 2000rms, I mean it really is that simple. Nobody here is going to say either are awesome amps.

Share this post


Link to post
Share on other sites

Why are you buying some of the best subs in the business and continue to buy cheap, crappy amps? I know a watt is a watt, but stick with reputable companies. Save money by buying used, but don't buy cheap garbage amps and expect great results.

Share this post


Link to post
Share on other sites

the answer to your question is: Crescendo BC2000D

Share this post


Link to post
Share on other sites

If I took a dump in your socks would they still keep your feet warm?

Now that is funny! lmao

Share this post


Link to post
Share on other sites

I think you have been on here long enough to know that it's a shit amp and everyone will tell you to get something better.

That amps not gonna put out shit. you will keep trying to get more by tuning up gain and clip the hell out of the ssds and blow one or both. Then your out a sub and will wish you listened to us by doing it right the first time and getting a quality amp..

Share this post


Link to post
Share on other sites

What it the coil configuration on the ssd's?

Share this post


Link to post
Share on other sites

In my country, amplifiers are so expensive, most people think Hifonics makes high quality amplifiers, and they love Audiopipe (amps, mids & highs, subs,...) !!!!!!!

When I tell them it's not highend, they become angry...But they don't want to pay the price !

Share this post


Link to post
Share on other sites

Why are you buying some of the best subs in the business and continue to buy cheap, crappy amps? I know a watt is a watt, but stick with reputable companies. Save money by buying used, but don't buy cheap garbage amps and expect great results.

I agree 100% 100 times over. If you're going to spend the money on some top quality subs then why the hell cheap out anywhere else? I'm not saying you need to go buy something like an MTX TE4001D, but you can find something of reputable quality that will fit about any budget, and if it doesn't fit your budget save up and expand the budget. I'm married with four kids aged 14, 12, 10 and 9. It's not EASY to save money for stuff like this but it's doable, it just takes lots of patience.

Assuming you have D1 coils for a series/parallel final load of 1 ohm, there's a host of amps that will fit the bill for about the same price as that POS Power Acraptastik. (Google showed it starting from $230 and up to over $300)

If used isn't a problem these are a couple of good deals:

Rockford T1500-1BDCP $290

Audison SR 1DK $240 (if I was in the market I'd be all over this one myself)

If it has to be new then I wouldn't be afraid of these:

Audiopipe APSM2000 $175 (I've not had enough experience with them to form my own opinion but many people seem to like them)

Massive Audio D3600 $300 (no personal experience but they seem to review well)

MTX TH1200.1D $300

Sundown SAZ1000D $300

The fact is you don't need the full total RMS to get them loud. Concentrating your efforts on making sure the enclosure is perfect will yield you better results than buying the cheapest thing you can that's rated for power it will never produce.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

    1. Recent Topics

        • 7 comments
        • 254 views
        • 1 comment
        • 216 views
        • 1 comment
        • 92 views
        • 1 comment
        • 80 views
      1. Box for 1 15" SSA ICON

        • 3 comments
        • 938 views
        • 8 comments
        • 1,854 views
  • Similar Content

    • By Wolfram Audio
      Now available on the SSA store! 
      I do NOT check PMs on here. For any questions, email [email protected]
      Wolfram Audio W-3000.1:
      Specifications:
      RMS Power @ 1 Ohm : 3,000 Watts x 1 Channels (14.4v) RMS Power @ 2 Ohms : 2,000 Watts x 1 Channels (14.4v) RMS Power @ 4 Ohms : 1,150 Watts x 1 Channels (14.4v) RMS Power @ 2 Ohms (Linked) :  6,500 Watts x 1 Channel (14.4v) Frequency Response : 10hz~350hz (+/-1db) Working Voltage : 10V-16V Signal-to-Noise Ratio (Sensitivity) : >90dB Efficiency @ 4 Ohms : 86% Low Level Input (Gain) : 8V - 200mV Low Pass Filter : 30Hz - 250Hz Bass Boost : 0 ~ 12 dB Subsonic Filter : 10Hz - 60Hz Phase Shift : 0-180 Degrees 4-Way Protection Circuitry Built-in (Thermal, Voltage, Speaker, DC) LED Power & Protection Indicators Master / Slave (Linkable) : Yes Recommended Fuse Rating : 300 Amps 1/0 Gauge Power and Ground Terminal Inputs Remote Level Control Knob Included

       
       
      Wolfram Audio W-1500.1:
      Specifications:
      RMS Power @ 1 Ohm : 1,600 Watts x 1 Channels (14.4v) RMS Power @ 2 Ohms : 900 Watts x 1 Channels (14.4v) RMS Power @ 4 Ohms : 530 Watts x 1 Channels (14.4v) RMS Power @ 2 Ohms (Strapped) :  3,200 Watts x 1 Channel (14.4v) Frequency Response : 10Hz - 350Hz (+/- 1db) Working Voltage : 10V-16V Signal-to-Noise Ratio (Sensitivity) : >90dB Efficiency @ 4 Ohms : 86% RCA Line Output : Yes Low Pass Filter : 30Hz - 250Hz Bass Boost @ 45 Hz : 0 ~ 12 dB Subsonic Filter : 10Hz - 60Hz Phase Shift : 0-180 Degrees 4-Way Protection Circuitry Built-in (Thermal, Voltage, Speaker, DC) LED Power & Protection Indicators Master / Slave (Linkable) : Yes Fuse Rating : 150 Amps (Linked: 300A) 1/0 Gauge Power and Ground Terminal Inputs Remote Level Control Knob Included

       
       
      Wolfram Audio W-600.1:
      Specifications:
      RMS Power @ 1 Ohm : 700 Watts x 1 Channels (14.4v) RMS Power @ 2 Ohms : 380 Watts x 1 Channels (14.4v) RMS Power @ 4 Ohms : 200 Watts x 1 Channels (14.4v) RMS Power @ 2 Ohms (Strapped) : 1,400 Watts x 1 Channel (14.4v) Frequency Response : 10Hz - 350Hz (+/- 1db) Working Voltage : 10V-16V Signal-to-Noise Ratio (Sensitivity) : >90dB Efficiency @ 4 Ohms : 86% RCA Line Output : Yes Low Pass Filter : 30Hz - 250Hz Bass Boost : 0 ~ 12 dB Subsonic Filter @ 24 dB Slope : 10Hz - 60Hz Phase Shift : 0-180 Degrees 4-Way Protection Circuitry Built-in (Thermal, Voltage, Speaker, DC) LED Power & Protection Indicators Master / Slave (Strappable) : Yes Fuse Rating : 30A x2 4 Gauge Power and Ground Terminal Inputs Remote Level Control Knob Included
       
      Wolfram Audio W-125.4:
      Specifications:
      RMS Power @ 2 Ohms : 175 Watts x 4 Channels (14.4v) RMS Power @ 4 Ohms : 125 Watts x 4 Channels (14.4v) RMS Power @ 4 Ohms (Bridged) : 330 Watts x 2 (14.4v) Frequency Response: 15hz to 35khz Low Level Input Adjustment: 0.2v to 8v Signal to noise Ratio: >90 dB Minimum Impedance: 2 Ohm Low Pass Filter: 50hz to 500hz (500hz to 5khz [x10]) High Pass Filter: 50hz to 500hz (500hz to 5khz [x10]) T.H.D. Continuous @ 4ohm : 0.05% Operating Voltage : 10v ~ 16V Fuse Rating : 40A x2

       
       
       
       
    • By Godsmack
      - 27 Raptor 1/0 AWG Ring Terminals $20 
      - Install Edge 5 pack remote wires [IEC P 3x5-6] 6 feet $15
       - 2 packs Install Edge 6.6 ft RCA cables [IRC GAC2] $7 each or $10 for both
       - 8 4 way Knu Konceptz 1/0AWG in 4 8AWG out $8 each or all for $55
       - 50ft 16AWG speaker cable spool $5 
      - Install Edge Remote wire [IEC P18 X5-6] 18AWG $5 
      - Knu Konceptz kolossus Flex 1/0 AWG Red power cable 44 ft $125; 8ft $25; 10.5ft $35 (all for 175)
       - 13 ft Q power 1/0 AWG Super Flex on spool $25; 15ft on spool $30 
      - Approx 400 ft 16AWG Q power speaker wire on spool $40
       - Stinger 150 amp circuit breaker $25 
      - 6 Install Edge Speaker Savers [IEC CAP 133] $6 per pack or all 6 pairs for $30
       - 2 2packs Rockford Fosgate 8AWG Ring Terminals $5 each or both for $7.50 -
       2 Rockford Fosgate Side mount battery terminals $9 each or both for $15 -
       Rockford Fosgate 2 output top mount battery terminal $10 
      - Rockford Fosgate RCA coupler $5 
      - Rockford Fosgate 10 AWG Amp kit (no RCA wires) 17 ft $30
       - Rockford Fosgate pack of 2 100amp MAXI fuses $10
       - Knu Konceptz Negative top mount terminal $10 - 
      Metra Honda Harness [BB-WHHDI] $10 -
       Metra Inpala/Monte Carlo [XSVI-2105] $35 - Metra GM 88-05 22 pin harness [70-1858] $5 
      - Pair of Dynex square box terminal cups $2
       - Dynex OEM Ford Radio removal tools $8 
      - Stinger Blue HPM voltage meter [SVMB] $15 
      - Tsunami Marine ANL fused distro, 1/0 AWG IN, 2 1/0AWG out $20
       - Generic ANL fuse holder, no cover $5 -
       Mini RCA stereo Y cable $2 - 14ft Raptor RCA cable $10 
      - 16 ft Monster RCA cable $20 -
       Stinger 1/0 AWG ring terminal $4 -
       2 2male 1female RCA adapter $5 each or both for $7.50 
      - 1 RCA to RCA dual male wire 9" $2 -
       2 Street wires RCA cables in bags 19.69 ft [ZN1260] $7.50 each or both for $10 -
       ANL fuses, 2 200amp, 4 250 amp, 2 300 amp, 4 100 amp, 2 500 amp. 500 amp are $5 per pair others are $3 per pair, or all for $30
      Total price when purchased individually: $761 Buy the whole lot: $650
      Open to trades, Nikon FX lenses and other photography equipment are of special interest. Feel free to contact with questions. Thanks for looking!!
      - Viper 500.4, missing xo cover, and right mounting feet. $300
      - MTX Road Thunder XO's for componants. $20 for the pair
      - Eclipse SC-8355/8365 XO's for componants $50 for the paid
      - Phoenix Gold Octane 4.0 2 amp. $150
      - JL Audio 500/1. Missing some side screws. Not 100% on what the guts condition is, and last I remember looking it was fine. $125
      - Digital Designs DD C1. $140
      ORIGINAL RE XXX 12" to come, as well as more amps. I'd love to sell everything as a lot, and am willing to make deals. Only thing trade wise I would be after is Nikon FX lenses, but feel free to offer up. Pics are all on the link below.
       
       


       
       

       

       










       








    • By matj1990
      So looking for some info about amplifier and efficiency. 
       
      I have a xcon dual 1ohm 10"  so i can run at either .5ohm or 2ohm What i would like to know is  1500w @ .5ohm or 1500w @ 2ohm the 2ohm amplifier would be drawing more power to make its wattage because of the higher resistance correct ?
    • By GarrettHarvey
      Getting two hds212s and wanna know what amp to get(sq brand) , and if i should get dual 2 ohm or dual 4 ohm. And if youve done this build, what are the box measures
  • Recent YouTube Posts

×