Need input

[kisswahili 0]

ok im runnin low on resources to complete my install..so i was thinking of ways to save some money...

Im going to be runnin 2 amps...a BX1000D and an older PG QX4150

fuses are 60 and 40

the Brutus takes 4 gauge while the PG takes 8

Now heres my question...i was gonna run 1/0 from the batt to the distroblock then split it into 4gauge and 8 gauge

Now instead im thinking of runnin 4gauge from the batt then split it at the distro block into another 4 and 8 gauge

Anyone against doin that?

[dave_Edwards 1]

the 4 guage power wire is the right way to go----buy a 1 4 guage to 4 8 guage distro block---then use the 4 guage for the BX1000D then use 2 8 gusge wires for the PG---do the same with the ground wires(that way you are maximizing the input voltage)

hope this helps

[kisswahili 0]

i never thought of using two 8 gauge wires....im not sure if they can fit but i will give it a try

[dave_Edwards 1]

i never thought of using two 8 gauge wires....im not sure if they can fit but i will give it a try

use ring Terminal ends on the wire---then just lay them over each other into the amp---alot easier that way.

Dave