Jump to content
Dano 00TA

Stick with the factory amp or replace?

Recommended Posts

I just installed a Kicker 10"sub enclosure/ZX400.1 amp and 4 Kenwood 6.5 component sets in my 2000 Trans am running them off the stock Monsoon amp. I have an older Pioneer GM-H120 amp sitting around collecting dust. Specs aren't that much at:

4 x 30W @ 4 ohms (0.05% THD)

4 x 45W @ 2 ohms (0.05% THD)

2 x 90W @ 4 ohms bridged (0.05% THD)

Would it be worth the trouble to replace the Monsoon with this?

Thanks in advance.

Share this post


Link to post
Share on other sites

If this was a real amplifier then for sure. Real question though is are you happy with how it is now? If so, then don't bother.

Share this post


Link to post
Share on other sites

I doubt you would notice much of a difference.

Share this post


Link to post
Share on other sites

Yeah, it probably wouldn't be worth it for the little gain I'd see. Thanks for the replies

Share this post


Link to post
Share on other sites

Could be a huge improvement, lol, you never answered my question.

Share this post


Link to post
Share on other sites

Could be a huge improvement, lol, you never answered my question.

My fault :trippy:

It actually sounds pretty good to me for what it is. I took from your post that it's not a very good amp and probably wouldn't be worth it to replace. If I go ahead and replace it does anyone make an adapter to fit the stock amp harness to convert it to rca jacks? I'm trying to keep the wiring intact in case I ever put it back to stock.

Thanks

Share this post


Link to post
Share on other sites

Id say you can buy my Alpine pdx f4 (100 wrms @ 2-4ohms) and make a worlds difference and call it a day. But dont think you wanna go that far yet ;)

Share this post


Link to post
Share on other sites

Could be a huge improvement, lol, you never answered my question.

My fault :trippy:

It actually sounds pretty good to me for what it is. I took from your post that it's not a very good amp and probably wouldn't be worth it to replace. If I go ahead and replace it does anyone make an adapter to fit the stock amp harness to convert it to rca jacks? I'm trying to keep the wiring intact in case I ever put it back to stock.

Thanks

That's something you might want to ask on a forum for your vehicle. Someone here might know, but if not I would personally ask there if it were me.

Share this post


Link to post
Share on other sites

I would definitely do it since you already have the amp. Even though It's low power I would test it and keep whatever sounds better.

Edited by ricksi30

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×