Just bought an AP1800.1 and...

[rodneydude23 5]

It has 4 gauge inputs... I know its not a huge deal but I wanted to use 0 gauge with it.

I know stinger makes 4 gauge to 0 gauge adapters but the way the inputs are on the amp those adapters won't work.

Would it be ok to just trim the 0 gauge down or should I just get a 4 gauge amp kit?

[Deto1992 5]

It has 4 gauge inputs... I know its not a huge deal but I wanted to use 0 gauge with it.

I know stinger makes 4 gauge to 0 gauge adapters but the way the inputs are on the amp those adapters won't work.

Would it be ok to just trim the 0 gauge down or should I just get a 4 gauge amp kit?

It sucks that the adapters dont work. There are some guys on here who will telll you not to trim but, in my opinion, triming down 0 gauge is much better than running 4 gauge power and ground cables.

[Notorious97200 339]

Trim it !

You can use a distribution block with 0 ga input and 4 ga outputs.

[slim2fattycake 85]

theres nothing bad about trimming down. just make sure not to have any frays.

[rodneydude23 5]

Nice nice, appreciate the help. I'm not trying to push the amp to it's limits. Just want to go the safest route.

[edouble101 314]

If I was going to trim I would also heatshrink the end tight

[Ohjay 116]

I would just trim it carefully and heatshrink that sucka