Chop"s 86' Cutlass

[Sencheezy 689]

Out of the mother fucking blue!! Gawd damn you! Nice update chop!

[mccleery3 166]

You underestimate his sneakiness

[nem 2,019]

Full force!

[shizzzon 461]

I am very very sneaky sir.

[swift 501]

Nice update Chop! Looking forward to this one!

[porkchop 304]

Thanks fellars!

Means alot to have my team supporting me!

It is my drive.

[altoncustomtech 773]

Awesome updates Chop!  Can't wait to see the doors done!

[porkchop 304]

SSA swag

[nem 2,019]

Like a Boss!

[porkchop 304]

Small update, but rather significant.

Started putting the zcons together last night.

It could of definetly went together smoother.

I have three of the four together minus soldering the terminals.

Hope to finish up the next weekend.

[mccleery3 166]

HELL YEAH!!

[nem 2,019]

Looking good!

[porkchop 304]

Zcon motor.

Note the gorilla tape residue. Undesirable.

If one should choose to ship and.want assure the screws are retained in the motor,

I believe masking tape would do fine, and not add this factor.

[porkchop 304]

Work station pic

[porkchop 304]

Getting closer:)

[nem 2,019]

Zcon motor.

Note the gorilla tape residue. Undesirable.

If one should choose to ship and.want assure the screws are retained in the motor,

I believe masking tape would do fine, and not add this factor.

 

The residue left from that tape makes it not worth using.

[porkchop 304]

I have the carbon fiber dustcaps as well, however, there were several issues that left me hesitant on using them.

Went with this crisp and clean bnib originals! I like them a lot.

[porkchop 304]

Nice! Can't wait to have them in the wall!

[porkchop 304]

These things are monsters truthfully....

I get chills looking at them!

[porkchop 304]

Zcon motor.

Note the gorilla tape residue. Undesirable.

If one should choose to ship and.want assure the screws are retained in the motor,

I believe masking tape would do fine, and not add this factor.

 

The residue left from that tape makes it not worth using.

This was a better than the others scenario in the pic.

It can be cleaned off, just not desirable to the recipient.

IMO

Lol at your humour, should I just toss them!? Haha

[nem 2,019]

 

Zcon motor.

Note the gorilla tape residue. Undesirable.

If one should choose to ship and.want assure the screws are retained in the motor,

I believe masking tape would do fine, and not add this factor.

 

The residue left from that tape makes it not worth using.

This was a better than the others scenario in the pic.

It can be cleaned off, just not desirable to the recipient.

IMO

Lol at your humour, should I just toss them!? Haha

No I meant using the tape. I tried it once and if you never have to remove the tape it is fine, but if you do there is some clean up.

[dbsupra 69]

Looking good chop!

 

What coil dd you end up going with?

[edouble101 314]

I am anxious to see those doors finished!

[mccleery3 166]

Sucks about the residue & the look but there should be no effect on performance, right?

Ready for the Cutty to start waking the dead

ZOMBIE BASS!!!!!

[Sencheezy 689]

Somebody has been busy since I've been gone! Nice updates.