Help with equipment settings

[Aurelios 0]

Looking for some help with what to put my settings at, I understand most of them, but not all of them. Was hoping you could give your educated opinions on what to set my equipment to. The equipment I am working with is a JL 250/1 (powering two American Bass 12's), an American Pro VS1407 (powering two pairs of Planet Audio 6.5's) and a Blitz 2-way crossover (has a remote bass knob with sub gain and frequency sweep). These are all the settings available to mess with.

JL 250/1

Full/Low/High

LP Filter

Mode/Slope

- Off/12dB/24dB

- 40Hz - 200Hz

Bass Control

Infrasonic Filter

- Off/30Hz

- 0dB - +15dB

Amp Input

Input Voltage

- Low/High

Signal Sensing

- Off/On

Single Input Level knob

American Pro VS1407

1/2 Ch

- HPF/Full

- 50Hz - 1kHz

3/4 Ch

- LPF/Full

- 30Hz - 250Hz

Bass Boost

- On/Off

Separate 1/2 Ch and 3/4 Ch Input Level knobs

Blitz 2-way Crossover

Single Input Level knob

Subwoofer

X-Over Freq

- 40Hz - 400Hz

Bass Boost

- 0dB - +12dB

Phase

- Normal/Reverse

Mode

- Stereo/Mono

Highs

Freq Multiplier

- x1 - 40Hz - 800Hz/x10 - 400Hz - 8kHz

X-Over Freq

- 40Hz - 8kHz

Separate Subwoofer and High Output Level knobs

[Aurelios 0]

If any other info is needed I can provide as much as I can, just wanting to make sure I do it right.

[Aurelios 0]

[Kanaworm$ 292]

Start with everything flat and adjust to where it sounds best to your ....

[mrbojang 8]

I would recommend searching the forums. There's a sticky somewhere I believe.