Noob question

[TwoFifteens 0]

I'm planning to buy two of the fully loaded Q15's, and I have a question regarding how to hook them up.

When I get them I plan to hook them together either in series or parallel and (This is where the question comes in) run off a monoblock Rockford Fosgate t2500-1bdCP.

Now since each requires 1000w rms would it be safe to run them at 1250 off of the 2500w monoblock? I plan to put them in a ported or bandpass style enclosure that'll take up most of my 43inx40inx17in (roughly) trunk. Would this be a good set up for the two woofers? And is that the correct power for them?

Also, the second question I somehow forgot, how would I wire two dual 1 ohm Q15's to get them to hook up to an amp at 1 ohm?

Edited July 30, 2010 by 2x15's

[sandt38 448]

Series parallel.

[TwoFifteens 0]

Series parallel.

Rock on, now about the hooking two Q15's up to a T2500-1bdCP amp? Would it be safe to run the whole 2500 split between the two subs? Or should I cut the power back a bit so they each only get 1000 watts?

[BJD3 0]

As long as you don't drive the amp into clipping (which you shouldn't be doing anyway), you'll be fine.

(I so didn't realize I haven't posted here yet.) 0_0

Edited July 30, 2010 by BJD3

[TwoFifteens 0]

As long as you don't drive the amp into clipping (which you shouldn't be doing anyway), you'll be fine.

(I so didn't realize I haven't posted here yet.) 0_0

Lol i'm pretty sure you're same guy who was helping me on SMD, i'm Dub7Banger. Thanks for the help on both forums!