box designs

[matt cusack 0]

Hey everyone. I am not sure what the policies are with box designs are here so i thought i would ask. If I asked for a design on the forum and someone does give me one do i pay them or what?? this is just a picture of the box. Like the dimensions of the pieces of wood. I could make the box but i have no clue on how to design a port or tune a box. If this was not clear or difficult to understand than let me know or just delete it , hha

Thanks,

Matt Cusack

Edited January 31, 2010 by matt cusack

[thebiggmann12 14]

RE Enclosure Calculator there ya go...check that out so u can make it as big as u want and tune it to what u want.

[matt cusack 0]

RE Enclosure Calculator there ya go...check that out so u can make it as big as u want and tune it to what u want.

Wow.. do i feel dumbb..haha thanks bro

Matt Cusack

[thebiggmann12 14]

lol shouldnt feel dumb...i use it too. its no biggie.

[raolito1980 2]

I'm trying to design my box now? Does anyone know if these measurements are pretty accurate? Thanks.

[thebiggmann12 14]

the measurements for the cut sheet are dead on, but the tuning is normally a bit higher than what it says it is.

[Duran 387]

If you want accuracy do the math yourself

[jcarter1885 995]

There are a few members who charge for designs then you have some that will help you with a design if you provide the size of the enclosure you want and tuning frequency if you want it ported. You can give the max dimensions of the area you have to work with and that will help to get you started on getting closer to a box design.

[Mac N Cheese 90]

If you want accuracy do the math yourself

x2

[b34tBoX 0]

If you want accuracy do the math yourself

x2

Where are the formulas/equations?

[BKOLFO4 29]

I have never used the RE calculator and the design come out correct!!!!

[porkchop 304]

If you want accuracy do the math yourself

x2

Where are the formulas/equations?

JL port length formula

try the JL port length formula.

[BanginGMC 23]

Was told by a very skilled box builder that website the with the calc. wasnt dead nuts.