getting a new setup need some advice

[aimone 4]

so im getting a brand new rf power hx2 15 thats been sitting since it was bought because the guy bought 2 of them years ago and only used one.

i also found a hifonics bxi2010 bnib never been hooked up for $180....i want the hifonics but the guy with the sub has a power acoustik bamf 5500 which should i get?

and im thinkin of taking my backseat out and walling between the cab and trunk. now the question about that is should i go sealed or ported?

im looking more towards spl then sq any advice will be very appreciated. im taking my time putting this setup in so its done right and not just thrown together like my last one

Edited January 29, 2010 by aimone

[NB50 206]

If those are the only choices, I'd choose the hifonics over the power acoustic and for spl go ported.

[aimone 4]

thanx....i was thinkin hifonics too since its brand new.....unless someone might have a sundown or AQ they might give a good deal on

about how many cubic feet should i make the box? and probably tune it in the low to mid 30's

[bigrank916 72]

thanx....i was thinkin hifonics too since its brand new.....unless someone might have a sundown or AQ they might give a good deal on

about how many cubic feet should i make the box? and probably tune it in the low to mid 30's

You could find a cheaper amp at 1k rms and match the driver.

The specs note 2-4 ft3.

[aimone 4]

got any cheaper amps bigrank? i've been lookin at crunch pzi's and some audiopipe. but im open to new ideas especially from someone that knows there stuf

i ffound the owners manual on RF 's site and got the specs and measurements for what they recomend. i just dont like the 4 round ports they say to use

and dont know the math for for all that to change it

[Kanaworm$ 292]

What kind of budget do you have for an amp?

[bigrank916 72]

got any cheaper amps bigrank? i've been lookin at crunch pzi's and some audiopipe. but im open to new ideas especially from someone that knows there stuf

i ffound the owners manual on RF 's site and got the specs and measurements for what they recomend. i just dont like the 4 round ports they say to use

and dont know the math for for all that to change it

I wouldnt buy the crunch but the AP is a great budget buy. They are a good deal and seem to have a good reputation as well. This might work. AP15001D

You dont have to use round ports if you dont want to. Try a slot port. Plug the numbers in on this calc and you can get a rough idea of what the enclosure will be. Its not perfect but it will get you close enough. RE calc