Sundown SAZ-3000D Wiring Help

[Kent535 25]

I Dont Really Understand how to bridge a Dual 2 Ohm Speaker,

On My Speaker I Have Positive Crosing Over To Positive And Negative Crossing Over To Negative (1 Ohm Load)

Like Shown

How Do I Hook This Up To The Amp?

Because The 2 Outside Terminals Which are Usually Positive Negative Are Positive Positive

Edited January 19, 2010 by Kent

[Kent535 25]

ANyone?

[viper167 1]

i think is on the right side of the speaker connection you gota hook up the neg from speaker to pos amp and pos speaker to neg amp

[CrazyKenKid 64]

umm hook the positives up the postives and the negatives up to the negatives, then branch off to the amp?

whihc amp are you using? is it a mono block amp? if so does it have 2 sets of input terminals?

[viper167 1]

if you go to sundownaudio.com and go under ur amp there is a spec sheet and shows you a pic of the wireing

[Kent535 25]

Yes I Have A MonoBlock

I Already saw the diagram but am still confused,

[viper167 1]

I think .....wire up ur sub like the picture you have then on the amp from left to right u have ur power connections then + - - + on the right side of connection - + connect ur + sub to - amp and - sub to our + amp from what i can see in the pic thats how you wire it

[NB50 206]

Just hook it up positive to positive and negative to negative. Your not bridging anything, bridging an amp refers to 2 or 4 channel amps.

[jcarter1885 995]

Just hook it up positive to positive and negative to negative. Your not bridging anything, bridging an amp refers to 2 or 4 channel amps.

x2, you can hook it up to either set of +,- speaker terminals on the amp and it will work.

[Kent535 25]

So My Sub Is The One That Is Bridged?

Since Its 1 ohm,

And so that means i hook it up on the 1St and 2nd Terminal since the two outside ones are positive?

[CrazyKenKid 64]

well if you have a mono amp with 2-set of output terminals jsut hook the positive leads and negatives leads to the amp, since internally it is in parellel already.

[CrazyKenKid 64]

remember you are NOT bridging the SUB you are hooking the sub in parellel to DROP the ohm load!

[Kent535 25]

Alright I Got It, Thanks Everyone.

Just got a little confused

[CrazyKenKid 64]

np man! glad we could help out!!! and we all get a little confused once in awhile!

[smullen 1]

Also on a Mono amps, like the SAZs, the dual ouputs are the same channel... Its for convienience and good connection as a lot of people want to use really heavy wire... Think of it as a Power Dstribution Block for your speakers..