Front Stage Idea

[PHATBOi 38]

Ok, so what about these http://www.millionbuy.com/mbqdsh216.html run off of this http://www.millionbuy.com/mbqdsc280.html? Thought I could make a baffle from 1/8" ABS plastic to fit them into my doors.

[PHATBOi 38]

I will be dynamating also. When I install the dynamat on the doors, where would be the key places to hit. Around the speaker hole and behind the speaker? Thanks.

[///M5 2,833]

Buy from SSD not dynamat, cheaper and better Link in my sig.

Those MB's could be fine if you like the way they sound. I wouldn't buy them without listening to a set first though. Not my cup of tea.

[PHATBOi 38]

Thanks for all the input guys. Finally made up my mind for sure. Going with MB QUART PVI216 (PVI216) 6.5" 140W PVI Series Component SPEAKERS 70 watts rms run off a MB Quart DSC280 80x2 at 4 ohms. Going to fab some mounting baffles for my factory 5x7 holes from 1/8" ABS plastic sheet.

[Impious 1,476]

It has NOTHING to do with oval or round and EVERYTHING to do with the fact that no one engineers a decent oval speaker these days. *exceptions always, but I don't know of any 5x7's atm

http://www.wooferset...nent-System.htm

http://www.wooferset...nent-System.htm

The 6x9's are supposed to kick ass, not much talk about the 5x7's however.

[///M5 2,833]

It has NOTHING to do with oval or round and EVERYTHING to do with the fact that no one engineers a decent oval speaker these days. *exceptions always, but I don't know of any 5x7's atm

http://www.wooferset...nent-System.htm

http://www.wooferset...nent-System.htm

The 6x9's are supposed to kick ass, not much talk about the 5x7's however.

Exactly why I said no 5x7 atm, those 6x9's are more than fine but not worth the price IMO. More than decent though

[danssoslow 0]

Not sure if you have picked up the ABS sheet yet, or what you are paying for it; but a super cheap alternative would be a couple HDPE plastic cutting boards from Wally world or Target. Cutting the stuff with a high speed blade or rotozip with a spiral bit will not cause much of a melting issue, if any. The stuff just comes off in shavings, is strong as can be, and dirt cheap to boot.

[PHATBOi 38]

Not sure if you have picked up the ABS sheet yet, or what you are paying for it; but a super cheap alternative would be a couple HDPE plastic cutting boards from Wally world or Target. Cutting the stuff with a high speed blade or rotozip with a spiral bit will not cause much of a melting issue, if any. The stuff just comes off in shavings, is strong as can be, and dirt cheap to boot.

Thanks, I am getting the ABS from the same place as my fuses and Stinger 1/0 to 5/16" terminals. 17" x 21" x 1/8" for like $10. Should work fine.