Tang Band 5 1/4" and 6 1/2"

[///M5 2,833]

I want to see you carry around an enclosure, an Rli8, an amp, and 2 AGM batteries. That'd be funny as hell.

[nem 2,019]

I want to see you carry around an enclosure, an Rli8, an amp, and 2 AGM batteries. That'd be funny as hell.

And one hell of a work out.

[SpeakerBoy 64]

I want to see you carry around an enclosure, an Rli8, an amp, and 2 AGM batteries. That'd be funny as hell.

Walmart sells AGM batteries that are roughly 5"x6"x3"

I'm not carrying a full size battery. I'm not the hulk.

I did forget, that my current backpack is rather heavy. The Rli looks pretty chunky too. So I could do the 8", but I probably wouldnt be very happy doing it.

I found out the power ratings on my Kenwood KAC-642 4ch

Note: All at 4ohm

(4ch) 16w Rms x 4

(3ch) 16w Rms x 2 + 45w Rms x1

(2ch) 45w Rms x 2

I figure there's some headroom for a stronger amp (I can drive my kenwood full out, with no problems). If my estimate is about right, I think i could pull off 200w-250 RMS.

Edited December 9, 2009 by DeepSubBoy

[SpeakerBoy 64]

I want to see you carry around an enclosure, an Rli8, an amp, and 2 AGM batteries. That'd be funny as hell.

And one hell of a work out.

I had a guy tell me once, if i could carry his sealed box, with two 15L7's, to the street corner and back, i could have it.

I made it a good twenty feet.

[SpeakerBoy 64]

I figured out why i either have massive port noise, or ridiculously high tuning. I never paid any attention to the port, other than noting that it was there. It is only like, 5" deep, 7" across , and 1/2" wide (Shaped like this [=====] ). I am going to extend it by adding the port from the other box to the current one.

Edited December 14, 2009 by DeepSubBoy