Power Acoustik BAMF 5500 guts

[SynCity 2]

well i was just taking the photo's off of my phone tonight and found these that i had in there. if anyone cares here they are

BAMF 5500

[jcarter1885 995]

I wonder how much power that amp puts out, you should bench test it or somebody.

[Kanaworm$ 292]

Looks clean and a well laid out design!

What is it rated at?

[shizzzon 461]

Wow, PA just convinced me to smack them across the face...

Apparently they have built this amp and probably the whole line 100% for market hype and what people hear through the grape vine of things to look for when purchasing a high powered amp...

Dual power n ground terminals.. Yes, a plus on amps that NEED them.. hint hint...

I can say that it has a nice case design.. is that it?

I doubt it can do it's 3,200w rating...

I don't know why but all high powered amps i see do not use onboard fusing... I don't know why that is but this does and is sticking out and i'm confused... I'm gonna go eat turkey...

[CrazyKenKid 64]

looks nice!! and x2 you should bench it! or send ti away to get benched! (to me lol jk)

[SynCity 2]

these amps bearly pushed my 2 ssd 15's. i mean for the money its okay. maybe a bit too much. if i knew how to bench i would.

[shizzzon 461]

honestly, if u could wire both of your 15s to a 2 ohm load, i'd opt for an Audiopipe 3000d for $310 when tryin to save some money if u want monsterous power.

Phi on here is runnin a pair of ssd 10s off that amp at 4ohm(2,000w) and they NEVER get warm! These SSDs want about 1,500-1,800w per driver non clipped for them to be reachin their thermal limits.

I must warn you though. Based upon my experience with the SSDs, if you do try and run that much power, make sure that the box that is being used is about the smallest size Fi's recommends or else they will bottom out in no time.

Phi has his 2 10s in a 3cuft box and his subsonic filter must be turned up in to the 50s to compensate for the low end. The box needs to be smaller for daily use.

[rushnrun 14]

looks like a decent 1500-2000 watt build... kinda low mosfet count... I don't know amps that well I just know what I look at... that's the same build as my swiss sdx2000a Different board but same type of layout and component quantity... swiss has more mosfets... does 2200ish...