Kerfed port box build - Icon 15

[dtcharneski 0]

Well woke up this morning ready to start building my new box for my Icon 15 everything was going good, then it started to rain. So had to pull the table saw back into the garage. I only had one last panel to cut for the port. I guess there's always tomorrow to finish it but heres what pics I have so far.

The Box is going to be 4.0ft cubed tuned to 31hz with 68 sq.in of port area

The Design

The Panels

The Kerf Cuts

The 45's

More pics and a finished product soon to come. Damn rain.

Edited November 10, 2009 by dtcharneski

[patented17 21]

Looks awesome, and also nice table saw lol.

[dtcharneski 0]

Looks awesome, and also nice table saw lol.

Thanks

[Aaron Clinton 2,372]

Looking great so far. It will love that box.

[mklett33 32]

What radius are you trying to get off those kerfs?

[porkchop 304]

looking good .

[dtcharneski 0]

What radius are you trying to get off those kerfs?

a little under 5 inches

[dtcharneski 0]

Thanks Denim and porkchop for the replies

Edited November 10, 2009 by dtcharneski

[mjmarovi 8]

Jacob has gotten great results with this kerfed box, I would expect great results from this as well

[Notorious97200 339]

looks good !

4 cu ft at 31Hz : wow The Icon will love it for sure, but you too will love it a lot.

with a kerfed port : it's always impressive (when you don't know how to do it!!!)

The port area seems to be huge when I look at my box!!!

[dtcharneski 0]

Jacob has gotten great results with this kerfed box, I would expect great results from this as well

I hope so