XCON 12" help!!!

[ron82nd 0]

Hey guys would 1.2 cu ft sealed be alright to run this 12" xcon sub with 1540 watts rms?

[johnecon2001 82]

That's right on the edge, but you should be fine. Add a little polyfill to help the response out.

[jcarter1885 995]

That's right on the edge, but you should be fine. Add a little polyfill to help the response out.

x2, or if you can try to make another box but if not you will be good to go with the polyfill.

[ron82nd 0]

With it being right on the edge will I miss out on the lows? Also would I be better off going with the FI Q due to box size? Also will there be a huge difference with the xcon over the q? I was told that the xcon will play higher and be alot louder.

Edited October 10, 2009 by ron82nd

[Aaron Clinton 2,372]

That box size is good. I did much of our prototype testing in a 1.1 cube box. As mentioned above by John and Jay-cee, you can add some polyfill if you like to make the Xcon think it is in a larger box. But either way, the Xcon will be good to go in that box size.

[ron82nd 0]

Thanks for the help guys.