Signal Delay?

[Lucky 76 5]

I am going to be running 4 saz1500 amps. My question is if I were to have the rca's signal go into the input of one amp and then use the outputs on that amp to connect it to the next amps' inputs and I do this for all 4 amps like a chain will there be a noticeable amount of signal delay? Would I be better off getting some form of rca block that has 4 outputs and run each output to it's own amp?

[Duran 387]

I am going to be running 4 saz1500 amps. My question is if I were to have the rca's signal go into the input of one amp and then use the outputs on that amp to connect it to the next amps' inputs and I do this for all 4 amps like a chain will there be a noticeable amount of signal delay? Would I be better off getting some form of rca block that has 4 outputs and run each output to it's own amp?

You can only strap two amps together.

[Lucky 76 5]

Yes but I do not want to strap the amps. I want to run each amp individually to its own sub. Would it be a better idea if I strapped 2 together and ran 2 subs to each of the strapped amps? I did not buy the subs yet.

[KU40 173]

I would strap two amps together. Then you can just split the signal and send it to each of the two pairs of strapped amps.

[Lucky 76 5]

Alright thanks. Ya that will make life a lot easier. Will I loose any power doing this?

[johnecon2001 82]

If you don't want to strap and you want to ensure the signal is in phase and output to all amplifiers equally...

Get the MaxxLink

http://www.onlinecarstereo.com/CarAudio/ProductDetail.aspx?Source=googlebase&ProductID=20093

[Lucky 76 5]

I have heard about the max link. I have heard of people using it and getting great results from it as far as spl goes. Would this benefit me more than strapping?

[Lucky 76 5]

My questions with the maxxlink are as follows

-If I were to use this without strapping my amps wouldnt it be the same thing as using y splitters?

-If I were to strap the amps using the maxxlink would there be more gains?

-I am using a 3sixty processor. Would the maxxlink screw up the signal generated by the 3sixty?

-Is the maxxlink my best option?