2 amps on 1 BTL

[loondizie52 1]

if you take a fully loaded btl D1 coils and wire up one autotek mean machine 1500d to each coil would it put each amp at 1 ohms since its a 1 ohm coil?

[Kanaworm$ 292]

Yes!

[loondizie52 1]

ok sweet thanks i was pretty sure just wanted to dbl check...and should i strap those or run one to each coil? and if i do strap, does it need that maxilink think or just do it the regular way

[Kanaworm$ 292]

ok sweet thanks i was pretty sure just wanted to dbl check...and should i strap those or run one to each coil? and if i do strap, does it need that maxilink think or just do it the regular way

I would strap to a 2 ohm load. Easier to set the gain. As far as the Maxxlink I could not tell you!

[KU40 173]

Read the owner's manual.

[Spencerk 4]

Strap them, not all amps are exactly identical, one may make more power than the other, their could be a time delay between the two amps even if its only 1 ms that could cause distortion.