Looking for a bit of guidance

[PhillBoy20XD6 0]

I have a pair of Alpine Type-R's dual 4 ohm version. I currently have them parallel to a 2 ohm load at the amp. I fear as though my amp sucks (i know this for a fact its a Volfenhag). My question to the amp gurus is what amp i should use for the pair. I could always parallel the remaining wires to a 1 ohm load to a mono block. Wondering what kind of amp would be the best.

Power Handling

* Power Range: 200 - 500 Watts

* RMS Power Handling: 500 Watts

* Peak Power Handling: 1500 Watts

Dimensions

* Mounting Depth: 195 mm (7.7'')

* Mounting Diameter: 275 mm (10.9'')

* Displacement: 0.071 cu. ft (Front Mount)

* Added Volume: 0.085 cu. ft. (Reverse Mount, Magnet Out)

General

* Frequency Response: 25Hz - 500Hz

While I'm in the market I also have a pair of RE-SX12's waiting in the wings perhaps I could get some recommendations on an amp for those. Both are DVC 2 ohm.

12"

Electrical Q Value -Qes: 0.32

Mechanical Q Value -Qms: 4.4

Total Speaker Q Value -Qts: 0.30

Free Air Resonance -Fs: 30.6 Hz

Equivalent Compliance -Vas: 47.6 liters

One-Way, Linear Excursion -Xmax: 22 mm

Efficiency -SPL 1W/1m: 88.1 dB SPL

Effective Piston Area -Sd: 480 cm^2

DC Resistance -Re: 1.9 ohm

Nominal Impedance -Znom: Dual 2/4 ohm

Thermal Power Handling -Pe: 1000 W

Force Factor -Bl: 21

[shizzzon 461]

sundown1500d-type R

Kicker ZX2500.1-RESXs

or

2 sundown 1200ds or AQ1200ds on RESXs

[Tirefryr 1,742]

So you're only running one coil on each driver?

[PhillBoy20XD6 0]

i'm running both coils on each driver

[PhillBoy20XD6 0]

thanks for the heads up shizzz i've really been looking at the sundowns i've seen alot of high power systems using them so i'm sure they are good

[jfin1204 2]

preorder sundown 2000d, and save some money.

[PhillBoy20XD6 0]

the new 2000d are more than the older 1500d although they are gorgeous.

[jfin1204 2]

even better.