Any box designers indahouse

[JimJ 11]

I'd like a box cabinet plan drawn up I don't know if I'm going with this design yet or not, but if I do I'd like to have a plan for it.

I'm basically doing a homebrew version of this: http://www.omegaloudspeakers.com/ts33.htm

Using these drivers: http://www.madisound.com/pdf/fostexcabs/fe126e_encl.pdf

If it models well, I wouldn't mind going with a tower speaker instead of a bookshelf - although I don't know exactly how it would react.

Thanks...

[JimJ 11]

***updated

alright, decided to switch drivers...now I'm looking at the upgraded model: http://www.madisound.com/pdf/fostex...s/fe127erev.pdf - end up losing 2dB of sensitivity...woohoo, I'll be at 94dB/1W @ 4 ohms. Plenty of efficiency.

http://www.madisound.com/pdf/fostex...27e_revencl.pdf - Recommended Fostex bass reflex enclosure is at the bottom. 10 liters tuned to 71Hz. All I need is a cabinet that fits two of these...

[Supa_c 1]

71HZ, nice

[JimJ 11]

yeah, but they're full range...no tweets...so the tuning naturally is going to be high

Trust me, the SQ is there...

[Supa_c 1]

Der, i forgot about the fullrangeness

[JimJ 11]

fullrangeness > all

no tweets, no crossovers, no problem

[JimJ 11]

after studying chem, my brain hurts

gimme some numbers...

[Supa_c 1]

fullrangeness > all

no tweets, no crossovers, no problem

<{POST_SNAPBACK}>

tis true

Still need a SSF though, unless your amp has one

[JimJ 11]

Still need a SSF though, unless your amp has one

doubtful...the amount of power at those frequencies aren't enough to cause overexcursion...

[Supa_c 1]

Oh yea...

your using tubes * cough* weak* cough*

[JimJ 11]

don't make me come over there...

Still doesn't answer my questions

[Supa_c 1]

Whats the question ?

[JimJ 11]

look at the picture

i need height, width, depth for a .706 cubic foot internal volume

given that a single driver's port is 80mm in length by 50mm diameter, what's the port for a box twice as big...and do i need to up the diameter to avoid port noise.

[Supa_c 1]

www.the12volt.com

figure it out yourself

You wont get any port noise from fullrangers

High tuning+ low tone+ cone movement= port whistle

[JimJ 11]

so something like that...anyone want to double check my numbers...

and what's the darn cutout diameter for a 3" precision port??

[Supa_c 1]

Ohh ohh

I know i know !!

5 1/4"

the flange is huge !

[JimJ 11]

5.25"...sheesh, bigger than the driver cutouts

But the numbers look good?