Help? Not sure on my Amp

[xxskatexx 0]

Sorry im somewhat new. done quite a few low end systems, but not familiar once it gets into amps and stuff. so any help would be nice.

I put in my order for a 12" SSD with Copper. i have a box that I built for the sub at 1.1 sealed. none of thats the problem. my question/problem is in the amp. I recently bought a Kenwood 9104D, and wanted to continue using it but not sure if its overkill. Was thinking of running my 12 at 1 or 2 ohms as my amp is 1 ohm. but spec wise it runs higher RMS. it runs 900W RMS. im pretty sure, just becuase an amp "says" it puts out a certain amount it doesnt put that out all the time. so technically it shouldnt matter? but im not sure, thats what i need help on. plus i was told Fi's can take quite a bit of extra wattage.

Any help or insight would be greatly appreciated,

Spyke

Edited April 9, 2009 by spykexx

[B7L|BL4Z3R 4]

that amp would be fine..

[NDMstang65 403]

It'l be fine!

Thanks!

Nick

[xxskatexx 0]

thanks guys. just had to make sure, didnt wanna kill such a fine piece of work =]

[xxskatexx 0]

plus absolutely everythign that can go wrong with this audio setup has lol