Help me with my box

[sick6ness 1]

This is going to be for a 12" dCON and I want to put it in its recommended sealed enclosure which is 1.2 cu ft. Just want you guys to double check on my specs for the box build, making sure the volume is right and all. Also do I need to use some of that box fill? If so how much

Thanks guys,

-Mike

[sick6ness 1]

Is this right? Doesn't seem correct to me with those red errors.

[johnecon2001 82]

If you're going for the optimal enclosure size, poly fill isn't really necessary. You can always add a couple pounds to see if it slightly changes the sound to your liking.

[sick6ness 1]

If you're going for the optimal enclosure size, poly fill isn't really necessary. You can always add a couple pounds to see if it slightly changes the sound to your liking.

Ok, are these dimensions good though?

[johnecon2001 82]

Good for what? If it fits in your car and gives you 1.2^3ft, than they're good.

[sick6ness 1]

Ok so here are the pieces I am going to need. Tomorrow I want to build the box the problem is the measurements. How am I going to measure for example top/bottom 14.53" accurately? When I convert it to a fraction to make it tape measure friendly I get 53/100. Which is not on a standard tape. What do you fellow box builders do in a situation like this. Am I overlooking something here?

[sound=vibration 34]

Ok so here are the pieces I am going to need. Tomorrow I want to build the box the problem is the measurements. How am I going to measure for example top/bottom 14.53" accurately? When I convert it to a fraction to make it tape measure friendly I get 53/100. Which is not on a standard tape. What do you fellow box builders do in a situation like this. Am I overlooking something here?

just go to 1/2 .03in is not gonna effect a sealed box drmastically at all so go 14 1/2in

[sick6ness 1]

Ok I was thinking about doing that, just wasn't sure how people normally do it. So on the 13.03 just round down to 13 then. That makes everything a lot easier.

[johnecon2001 82]

lol .53 = 1/2"

[coobies5 43]

lol, if you want it to be exact, or close to, just cut a little more then 1/2" and sand it down or just round it off to 1/2" and be set.