Jump to content
Sign in to follow this  
the mange

do bigger batteries put more strain on the alt?

Recommended Posts

im upgrading my battery, and im obviously wondering if theres some kind of limit as to how many amps the new batt could be before i start damaging the alt? and do bigger batteries NEED a big alt or would say a 1500 amp batt be ok with a 120amp alt? i guess i just need a batt that my alt can actually recharge.... im really clueless when it comes to batteries and alts any help is greatly appreciated!

Share this post


Link to post
Share on other sites

im wondering the same

edit- well you think it would be less starin beacuse they have more power wich is making the alt have to do less to keep it charged

Edited by stuartgoodenough

Share this post


Link to post
Share on other sites

look at it like this the battery is a reserve, your alternator produces power for both the car and battery.

So, ur car pretty much runs on your alternator, when u need more power it taps into the reserve/battery.

So yea if ur draining your battery faster than u are recharging it u might have some problems.

A bigger battery will just have a bigger reserve capacity.

Share this post


Link to post
Share on other sites

edit - below is just an explanation of the alt trying to charge the batteries in a situation where the system draws more than the alt can provide. As already stated, if you alt can keep up with the system, the battery is just used as a reserve or to aid in high current peaks.

Bigger battery = more plate area.

More batteries = more plate area.

More plate area = need for more charging capacity.

Think about it:

1 battery, 1 250 amp alt. alt can charge that battery with 250 amps.

10 batteries, 1 250 amp alt. alt can only charge each battery with 25 amps.

I thnk I have finally just fixed my van charging (fingers crossed). 15 batteries and 1 alt is hard on the alt :D

Brian

Edited by BKOLFO4

Share this post


Link to post
Share on other sites

The difference between one an multiple batteries is not strain on the alt for a given amount of current from the reserve, it's merely the amount that the voltage will drop as that reserve current is being tapped. Think of the alt and battery in terms of an air supply system for pneumatic tools. You can't really run an impact wrench on just a compressor or a compressor with a small tank. Add a large tank, and the compressor motor itself isn't that important any more as long as on average the air that you remove from the tank can be replaced. The larger the tank, the better the tank hold pressure under drain. Just like the compressor in an air system, your alt doesn't handle transient load. The reserve does. It's really only when the sustained draw from the system becomes high, that the NEED to upgrade the alt/compressor exists.

Share this post


Link to post
Share on other sites
The difference between one an multiple batteries is not strain on the alt for a given amount of current from the reserve, it's merely the amount that the voltage will drop as that reserve current is being tapped. Think of the alt and battery in terms of an air supply system for pneumatic tools. You can't really run an impact wrench on just a compressor or a compressor with a small tank. Add a large tank, and the compressor motor itself isn't that important any more as long as on average the air that you remove from the tank can be replaced. The larger the tank, the better the tank hold pressure under drain. Just like the compressor in an air system, your alt doesn't handle transient load. The reserve does. It's really only when the sustained draw from the system becomes high, that the NEED to upgrade the alt/compressor exists.

That is the best comparison Ive seen!

Share this post


Link to post
Share on other sites
The difference between one an multiple batteries is not strain on the alt for a given amount of current from the reserve, it's merely the amount that the voltage will drop as that reserve current is being tapped. Think of the alt and battery in terms of an air supply system for pneumatic tools. You can't really run an impact wrench on just a compressor or a compressor with a small tank. Add a large tank, and the compressor motor itself isn't that important any more as long as on average the air that you remove from the tank can be replaced. The larger the tank, the better the tank hold pressure under drain. Just like the compressor in an air system, your alt doesn't handle transient load. The reserve does. It's really only when the sustained draw from the system becomes high, that the NEED to upgrade the alt/compressor exists.

That is the best comparison Ive seen!

yes amen brother that explains it quite well thank you.

Share this post


Link to post
Share on other sites

He is on the tech team for a reason. ;)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×