Wiring my icon to my 1000D

[Juslivin 1]

I plan to wire my sub to my amp like this,

My question is, would it be the same if i ran 1 positive wire out of 1 positive terminal on the amp into 1 positive terminal on the voice coil and the other positive terminal on the amp to the other positive terminal on the other voice coil and the same for the negative?

[bigtoepfer 0]

it would be a waste of wire to do that. Its easier to just run the jumpers from each voice coil to another

[dbjunior 0]

it would be the same the outputs are the same post just two hookups so it will still show up as the same load to the amp

[RobClay 20]

what are you trying to wire it to? 1ohm

[jonbearsmt 919]

no telling he did not list the v/c value,

its weird i see you give EVERY one advice, but in the last week i have seen you ask THE sillyest questions.

how to run an amp kit,

and how to wire your sub to your amp.

[RobClay 20]

ok i saw in your other thread you have an icon D2. heres some wiring options.

1ohm load

4ohm load

should be very simple.

[akjay907 0]

haha times twooooo what bigjon said, are you just trying to wire parallel for 1 ohm? that amp has internally bridged channels.

[Juslivin 1]

Can you guys not see the picture in my first thread? I know how to wire my amp to my sub....... I'm asking if i can do it the way above.

[RobClay 20]

Just wire it like that then...