Welcome to the IHoP

[Adrian_D 520]

seems like the stupid delivery driver "didn't find anyone home". and i got no phone call, no note, nothing saying my package is at the warehouse.

one angry phone call and my deadener showed up in 2 hrs.

[ramos 2]

Uh oh , now they are comparing you and I sean

[JimJ 11]

much to the chagrin of others I will say

home > car

Werd.

and now i'm looking for a turntable

muhahahahaha

[Aaron Clinton 2,372]

[ramos 2]

Looks like you would have to go the route I did in the chitbox mr. denim . I had to pull the doors off

[Aaron Clinton 2,372]

These are the two shots I just took of the door and the space where I cannot get wire through.

[///M5 2,833]

Uh oh , now they are comparing you and I sean

My post was informative, he should start over. Not sure I am going to post that though.

[///M5 2,833]

Aaron, is the grommet up high or down low it is hard to tell from the pics.

[Aaron Clinton 2,372]

Looks like you would have to go the route I did in the chitbox mr. denim . I had to pull the doors off

I am not that dedicated to this install.

[///M5 2,833]

Vaseline and putting it in in reverse usually works.

* idb

[ramos 2]

Take it greasy , it goes in easy

[Aaron Clinton 2,372]

Aaron, is the grommet up high or down low it is hard to tell from the pics.

Door is mid level, body grommet is up high. But the problem is that it has plastic clips that hold it to the door and the body at the end and they are only large enough in ID to fit the stock tiny gauge wire and no more.

Might have to getto it up some how.

[ANeonRider 3]

I have more than 60 in my doors though

As do I.

[Aaron Clinton 2,372]

Maybe a new hole in the door and the body is the best solution.

[///M5 2,833]

Good luck getting a drill bit in the door side.

[topgun 262]

Heat up a metal stick and make a new hole in the grommet.....

[Aaron Clinton 2,372]

Still the problem of getting inside access to the body side of the wire tube, means removing the dash.

[ramos 2]

In the chitbox , the grommet wasn't the problem. The molex plugs ( one in the door and one in the body ) were

[ANeonRider 3]

And here all this time , I thought the idea was to NOT get filler and resin on the carpet . Wtf was I thinking this whole time by making trim panels and stuff

I accidently dripped some on my rear seat cushion

[topgun 262]

See if you can thread a weighted string or something through the dash, tie the wire on the end and pull it through.

[Adrian_D 520]

I have more than 60 in my doors though

As do I.

crazy bishes

[ANeonRider 3]

Makes way more sense for a daily as well

Werd. Buddy of mine is purchasing one of the old big vans (think murals & shit on the sides, bed & table in the back, swivel lounge chairs)... going to do something SPL in it, since it's HUGE & won't be a daily.

[topgun 262]

I have more than 60 in my doors though

As do I.

crazy bishes

Is there anyone into this hobby that is sane??

[ANeonRider 3]

Now I flip burgers for a living

Apparently everyone that thinks that is a complete clusterfuck is a burger monkey.

[topgun 262]

NP: Dire Straits, Sultans of Swing