Jump to content
Sign in to follow this  
Juslivin

Quick questions,

Recommended Posts

Okay so i am getting a new system and i have few questions.

1. Why would i want 2 ohm subs over 1 ohm?

2. If i run 2 Subs to a mono amp what ohm do i want the subs to be?

3. Does everyone use both voice coils of subs? Whats the difference between using 1 and 2 coils.

Thanks,

Drake

Share this post


Link to post
Share on other sites

1. Depends on your amp.

2. ^^^

3. Running one coil = dead subwoofer

Running two coils = bass!

Share this post


Link to post
Share on other sites

You match the impedence of the subs to the amplifier. If a sub has two voice coils, there are very few instances where you would want to only use one. Plan on using any and all of the voice coils a sub has.

Share this post


Link to post
Share on other sites

You must use both voice coils. The different ohms are to allow you to wire the subs to a certain final impedance that your amplifier is stable too.

Share this post


Link to post
Share on other sites

Okay, so i am planning on getting 2 FI bl 15's and a SAE-1200D. Is this enough to power them? I want very loud low bass. Do i get the 1 ohm or 2 ohm subs? Do i need more than the stock battery and alternator to run the SAE-1200D? I am planning on using a 2 farad capacitor and doing the Big 3. Will my lights dim or will i not know that until i try it?

Thanks again,

Drake

Share this post


Link to post
Share on other sites

Don't Evereverevereverevereverevereverevereverevereverevereverevereverever Use A Cap. Ever....Ever.

Share this post


Link to post
Share on other sites

i ran a saz 3000d on my 2 15 bl's

Share this post


Link to post
Share on other sites

Okay, so don't use a cap but will a SAE-1200D be enough power or should i go with the 3000D? Will i need a new alternator/battery with the 3000D?

Thanks,

Drake

Share this post


Link to post
Share on other sites

With what you want, I would get two fully loaded BL's and the 3000D. Look into upgrading your main battery and also consider a secondary cell.

Share this post


Link to post
Share on other sites

i went with three and a h/o to start with... i went thru a few alts, and my amp ran hot....

how i have 5 agm cells and a h/o

i have some where like 250 amp hours now...

amp runs cooler, no problems at all

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×