Diamond Audio TDX-15D2 enclosure

[alvitae 0]

I picked up a tdx 15 dual voice coil 2 ohm for $100 in a pre-fab box. 1200 watts rms. Hooked it up and found out the box is broke. It sounded like Donald Duck getting kicked in the nads.

I would like to build an spl box for it but after googling my fingers off I can't seem to find any box spec recommendations. I was hoping to find a simple slot port build or something because I am still a noob and don't quite understand the Qs's and the other mysterious letter number references on the tech sheets

Any ideas or opinions would be appreciated. I prefer spl over sq.

Edited August 2, 2008 by alvitae

[Aaron Clinton 2,372]

Do you have the T/S parameters handy? It would help people get some ideas together.

[alvitae 0]

Here goes. Not sure what it means, I hope the t/s's are in there. But as far as box building goes I'm a carpenter and understand dimensions and building techniques.

Diamond audio mailed this to me after I posted. So they recommend 1.65 cubic but I doubt thats optimum for spl.

spl-86.5

qms-3.5

qes-0.60

qts-0.51

fs(hz)-33

Vas(L)-22

cms-0.066

Mms-330

sd (m squared) 0.0487

BL(t.m)-21

Re(ohms)-3.85

xmax(mm)-24

Znom(series ohm)4

Vented enclosure

Vb-1.65 / 1.2

f3-33 / 38

fb-33

ports-1

port i.d.-4"

port length-12"