Nightshade Recone

[bose301s 1]

Would a Nightshade recone fit in a SSA Icon motor?

[sundownz 197]

I doubt it.

[bose301s 1]

I doubt it.

Too small of a gap? The Icon has a decent sized gap.

[sundownz 197]

Pretty sure the icon is a 4-layer - the NS has an 8-layer coil, it probably won't go in with sufficient clearance.

[bose301s 1]

Pretty sure the icon is a 4-layer - the NS has an 8-layer coil, it probably won't go in with sufficient clearance.

You're right, darn, that would have been an interesting frankensub, lol.

[sundownz 197]

If you have a caliper and can measure the gap I can tell you for sure.

If it's a thick round wire 4-layer the 8-layer flat *may* go in. I wouldn't hold your breath... but my 8-layer will fit in a TC-9 motor.

[bose301s 1]

If you have a caliper and can measure the gap I can tell you for sure.

If it's a thick round wire 4-layer the 8-layer flat *may* go in. I wouldn't hold your breath... but my 8-layer will fit in a TC-9 motor.

Sadly I have no calipers. I am sure denim would know, I may PM him this thread.

[mrogowski 6]

And you call yourself an EE

[bose301s 1]

And you call yourself an EE

Hey, I am an EE not an ME, lol, I have DMMs and O-Scopes, not calipers

[Aaron Clinton 2,372]

I think it will cutting it too close.

[bose301s 1]

Ok, no big deal, just thought it would be an interesting idea to try.