What options should I get on SSD

[scizzle 0]

I am going to get 2 SSD 12's. I don't know what options to get on these as far as Dual 1 ohm or Dual 2 ohm, Flatwind coil or Copper coil and what is the BP option?

[Conquest4Life 0]

Flatwound coil (+$20)

[sick6ness 1]

I also had the same question about the Dual 1 or 2, and the ohm loads they would have on the amplifier for one or two subs.

[johnecon2001 82]

What amp do you have?

[audio-neon 34]

2 Dual-2 subs can be wired for .5 ohms or 2 ohms or 8 ohms.

2 Dual 1 subs can be wired for .25 ohms, 1 ohm or 4 ohms.

Depending on the amp you have dual 1 is most likely the best option for most of the car audio class D amplifiers (but check and see what the lowest supported impedance your amp can handle. (or in my case you would check and see at which impedance the subs will get the right amount of power because I have beastly amps).

[sick6ness 1]

2 Dual-2 subs can be wired for .5 ohms or 2 ohms or 8 ohms.

2 Dual 1 subs can be wired for .25 ohms, 1 ohm or 4 ohms.

Depending on the amp you have dual 1 is most likely the best option for most of the car audio class D amplifiers (but check and see what the lowest supported impedance your amp can handle. (or in my case you would check and see at which impedance the subs will get the right amount of power because I have beastly amps).

And I'm guessing Dual 1 can be wired at 1 ohm or 4 ohm?

Edit: Most class-d's run on 1.5 - 4 ohms

Edited May 5, 2008 by sick6ness

[JimJ 11]

And I'm guessing Dual 1 can be wired at 1 ohm or 4 ohm?

Either 1/2 or 2, for a single driver.

[slim2fattycake 85]

id get bp power 2

[KU40 173]

and get the nuclear reactor option. Do they have those?

[sick6ness 1]

And I'm guessing Dual 1 can be wired at 1 ohm or 4 ohm?

Either 1/2 or 2, for a single driver.

Thanks Jim makes more sense now