2 12" Mag and Sundown SAE-1000D Wiring question

[leftanddie 0]

Ok so When it comes to this wiring stuff and ohms I'm very dumb.. So anyway like it says I have two 12 inch mags and 1 Sundown sae-1000d amp. What I would like to know is how do i wire the 2 subs to the 1 amp and what ohmage (if thats even a word) and what power would the subs be recieving.. Sorry for my ignorance but any help would be appreciated. Thanks in advance guys.

[Acidburn 10]

Wire the coils in series on each sub. Wire the 2 subs in parallel with each other. This will give you a 2 ohm final load. They'll see a few hundred watts.

[johnecon2001 82]

Or like this since this was the only picture I could find.

[gonpostal 0]

Or like this since this was the only picture I could find.

why not do a all parallel to 1 ohm load?

[gonpostal 0]

here ya go http://www.jbl.com/car/product_support/Sub...aspx?type=2-4-1

[johnecon2001 82]

Or like this since this was the only picture I could find.

why not do a all parallel to 1 ohm load?

You can't wire 2 DVC2 ohm subs to 1 ohm

[Acidburn 10]

here ya go http://www.jbl.com/car/product_support/Sub...aspx?type=2-4-1

They're DVC2 ohm drivers, not DVC4 ohm ones. Going all parallel with these would lead to a 1/2 ohm final load.

[Aaron Clinton 2,372]

If you wired the subs to 1/2 ohm mono, you could void the warrenty on your nice amplifier.

[datsnowboy 0]

go here it gives you all your options wiring options