How is the SOUNDSTREAM PCA2.760

[KiCk'Z L7 0]

I have a 12" kicker l7 2ohm dvc sub needs 750watts rms i would like to get the kicker 750.1 but i cant wire it to 2ohms to get 750watts so i have to go with something like this. Also are hifonics amps any good?

# No. OF CHANNELS: 2

# OUTPUT (watts):RMS @ 4 Ohms 220x2

# RMS @ 2 Ohms 380x2

# RMS @ 4 Ohm Mono 760x1

# T.H.D.: 0.02%

# FREQ. RESPONSE (Hz): 10 - 30k

# SIGNAL TO NOISE RATIO: >97dB

# DAMPING FACTOR: >200

# INPUT SENSITVITY: 0.5 - 4.0V

# CROSOVER SLOPES: 12dB

# CROSSOVER FREQUENCY: High-Pass(Hz) 50 - 600

# Low-Pass(Hz) 50 - 150

# SUBWOFFER EQ: 0 - 18dB 0

# SUBWOOFER EQ FREQ. (Hz) : 40 - 120

# DIMENSIONS (INCHES): 9.5x2.5x20.0

# Fully regulated MOSFET power supplies

# PWM circuitry

# Tri-guard amplifier protection

# IDI (Intelligent Distress Indicator) gives a visual indication of the amplifiers protection status

# Platinum RCA inputs and outputs

# Line Outputs

# Bi-linear selectable crossovers for inputs and outputs (Hi/Full/Low)

# Continuously variable high and low-pass crossovers

# Variable subwoofer equalizer

# Phase inversion switch (0 - 180)

# OEM floating ground input

# Platinum 4-gauge power connectors

# Tri-mode operation

# Optional Remote Bass Control (EGA-RM)

# 2-YEAR WARRANTY

Do these amps have alot of problems?

Edited January 10, 2008 by KiCk'Z L7

[johnecon2001 82]

You need either 4 ohms or 1 ohm... soooo I'd say start looking for a one channel amp that can hit the full spectrum of ohm loads rather than a two channel amp that only does the power you need at 4 ohms bridged.