100.4 6-channel wiring question

[JazzScreamer 1]

If I use the first four channels for a front stage (woofer/tweets), would I be able to run a pair of coaxial's for the "5th and 6th" channels in the rear doors. The coax's will be 4 ohm models.

[Jybfan04 1]

I don't think thats possible as its only a 4 channel amp...

What u could do is run your woofers and tweets passive on 2 channels and then run the other 2 speakers on the remaining channels... I believe you would need a crossover for this tho...

[JazzScreamer 1]

The manuel has a six channel config. Check it out.

[sundownz 197]

If your front components have passive crossovers thats fine.

[johnecon2001 82]

The manuel has a six channel config. Check it out.

It's not a six channel amp, it's a 4 channel. That's not going to change. The wiring in the manual is just a way of wiring other speakers up.

I've never seen anyone use that particular wiring scheme, perhaps Jacob can shed some light why it's even in the manual.

[sundownz 197]

Oh... you are talking about running "tri-mode" on each set of channels eh ?

If so... then you won't be able to use the crossovers on the amp without have weird response from the coaxials.

Rarely someone would want to do this to run speakers and a woofer from the amp... but it requires passives to be effective.

[JazzScreamer 1]

Duh....I didn't think about the crossovers on the amp. This will not work for the setup I was thinking. My bad.