wiring questions

[mazzasec 0]

Would i need to get the dual 1's or dual 2's to get a 1ohm load out of the amp and also how would i wire them to get the 1 ohm load

http://www.the12volt.com/caraudio/woofer_c...sp?Q=2&I=42

is that the right wiring even though it says its for 4 ohms?

EDIT: if i were to get TWO of them

Edited November 20, 2007 by SEC

[johnecon2001 82]

You need a DVC 2 ohm sub.

Wire both of the positive leads of the voice coil to the positive leads on the amp. Same with the negatives.

[flakko 1]

there you go

[mazzasec 0]

so get the dual 2's?

and wire it like the first diagram in this picture?

http://www.the12volt.com/caraudio/woofer_c...sp?Q=2&I=42

Edited November 19, 2007 by SEC

[johnecon2001 82]

Sorry, what I said before is not correct. I didn't realize you had two subs.

You need the Dual 1 ohm coils. Wire each sub in series (negative to positive) and then wire the two subs together in parallell.

Wire just like that (just ignore the fact that they are DVC2 ohm coils, you need DVC1)

[Kold_Killa 0]

Yea, it's confusing how you are asking....

Are u getting 2 subs, or just one??? If just one, you want to get a dual 2... If you are getting 2, you want to get dual 1...

[mazzasec 0]

Sorry, what I said before is not correct. I didn't realize you had two subs.

You need the Dual 1 ohm coils. Wire each sub in series (negative to positive) and then wire the two subs together in parallell.

Wire just like that (just ignore the fact that they are DVC2 ohm coils, you need DVC1)

so thaat would be the right wiring even though its says its getting a 2 ohm load in the picture?

[johnecon2001 82]

Sorry, what I said before is not correct. I didn't realize you had two subs.

You need the Dual 1 ohm coils. Wire each sub in series (negative to positive) and then wire the two subs together in parallell.

Wire just like that (just ignore the fact that they are DVC2 ohm coils, you need DVC1)

so thaat would be the right wiring even though its says its getting a 2 ohm load in the picture?

Correct, the wiring is correct the picture is wrong.