Jump to content

Recommended Posts

Hi Guys,

I just installed my front stage a few days ago and now I have a nice problem. The amp I am using for my frontstage is a Memphis 16-ST300. When I'm on the road, it happens really often that the front stage stops for a second or two and then it gets back. During this time, the sub amp which is a Memphis 16-ST1000D doesn't even stops. I just don't know what to do right now.

Thanks,

Maxime

Share this post


Link to post
Share on other sites

Sounds like a a low voltage issue. Class d amps will usually operate at a lower voltage than A/B. Do you still have the stock alt ? I would see if you can reproduce what is happening while the car is running and sitting still. Then use a dmm and check the voltage going to your front stage amp. I betcha there is a huge voltage drop that is causing the problem. :)

Share this post


Link to post
Share on other sites

See there I go assuming again. :D That would be a good idea to check the wring for that particular amp first :)

Share this post


Link to post
Share on other sites

Hi Guys,

I just removed the amp and wired it back again but now the protection light turns on. I would like to know what should I do next =\

Thanks,

Max

Share this post


Link to post
Share on other sites
Hi Guys,

I just removed the amp and wired it back again but now the protection light turns on. I would like to know what should I do next =\

Thanks,

Max

check voltage on the power wire---then check the ground were it connects to the chassis of the car---check for resistance.

If they are all ok---I might be able to bust open the boards and check them for you.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×