Search the Community
Showing results for tags 'Aero port'.
Found 2 results
-
Wassup guys I'm doing a port swap in the next few days and trying to get opinions/suggestions. I have a box 39.5h x 41.5w x 13.5" d (outer dimensions) with a port 12h x 10w x 40" l which gives me 6.8 cubes tuned at 31hz with 17.75 port per cube. It's just not giving me as much pressure I want on lows. The new port is 12" o.d. Pvc (11.5" I.d.) x 36" l with 2-4" external. This will give me about 8 cubes tuned at 29 with 14.25 p.p.c. I don't have anything to lose, and I'm not building a new box until I design a 6th. So what are your thoughts on what I have now?
-
Enclosure design questions for 2 Sundown SA12s in 4.05ft>3 @ 30htz
10rogerd posted a topic in SPL & SQ / Fabrication
Hello all, I'm new to this forum, but not to car audio. I am however new to the Sundown woofers. I'm hoping you all can lend some help and thank you in advance on my enclosure design. What I have is an 05 Acura TL I'm doin a pair of Sundown SA12s in the trunk. Subs to be fired foward and a 6in Aero either out the back or side. I have tried several enclosures with foward fired subs & port, but the car just did not really like it. Last setup was a single CV Stroker12, power was supplied by an O.S. USamps VLX400 1ohm mono. I had good results with two 4in PVC ports fired back, Sub obviously foward. Then tried a 6in Aero out the drivers side of box. The Aero was slightly better. Anyway, my questions are... I have roughly 31in wide/26in deep and 13.5in tall to work with. I have an enclosure drawn up already with a net volume of 4.05 ft>3 and Torres is telling me with the 6in Aero @ 17in long this will yield me a tune of 29.64htz. Does this sound rite? I do want it to play very low!! I Only play music. Rap/Hip Hop/R&B/Funk/lil bit of rock/metal. My other concern is how will these subs like this size enclosure with the brutal power of the VLX? Amp is "rated" @ 2400 wrms @12.5v. Charging system is decent with a total of 4 large batteries and a 50farad Stinger Cap. All power/ground wire is 1/0 Monster Cable. Voltage playing it hard stays in the mid to high 13 volt range. Any input on if this will work fine would be great! Thanks again everyone.
