thebiggmann12

y dont u look at some other subs? like ssa, sundown, ascendant audio, dc, there is alot of different brands...ik the ssa subs get pretty loud sealed. u could do a 10" icon. just take a look at the ssa store, lots of subs in there that might suit u better.

Will do. I'm thinking about making some sort of frame around it and then bolt it to my car, but I'll check around to see what other people have done as well. My questions was actually how big difference it is between sealed and vented if you want to subs to hit hard at low frequencies. Because if a sealed enclosure could make the subs hit hard at 25-30hz, I would of course built it then a vented one. Cause I'm not looking to have a lot of sound pressure, my goal is a good sounding system with the ability to hit hard at low frequencies. Since I'm gonna use a 3200W rms amplifier I'll get some sound pressure either way. So I wasn't having that as a primary goal. I started this topic becuase I was afraid that if I made a sealed enclosure that it wouldn't play well on low frequencies. u should probably keep ur gains down, especially if going 10 cubes per sub...1600 watts is 600 more watts than what the subs are rated for...ur just asking to blow them to peices in that big of a box.

what is in there?

the bl is more get loud no matter what, while the q just sounds good and still can get loud.

make the port width 2.5" and the second length 3" and then build the box exactly how it looks. then just instead of cutting the hole for the sub on the same side as the port, cut it on the top.

i had mine ported tuned to like 28 hz or so...and the lower you tune the more u lack in the higher frequencies...but if u like low music i would tune around 28 hz.

the ssa store right here sells xs power...thats what im gonna get

i think running more than rms is a waste. unless competition is involved.

I heard that there will possibly be a couple event in Danville this year.. I might see you there is they do have one. Galesburg here... the danville events were decent last season... (MECA) where are they?

absolutely insane.

holy shit really? that would b sick...if u hear of any let me know.

no shit? ur not too far from me. im in danville.

swap out the rca's...might have gotten a bad set.

where u at in illinois?

personally i would take the backseats out and tune the box really low...but thats just me.

did u do the wiring urself? check ur remote wire.

Not planning on it in the near future. Market is too small... two 4500s and there ya go

it really just depends on where you live...its like 25 bucks a sheet here, but ive heard of guys who get it for like 12 a sheet where they live.

the measurements for the cut sheet are dead on, but the tuning is normally a bit higher than what it says it is.

lol shouldnt feel dumb...i use it too. its no biggie.

RE Enclosure Calculator there ya go...check that out so u can make it as big as u want and tune it to what u want.

i like hifonics and havnt had any problem with them... u can also go with the ap3000d and set ur gains down, they are about 300 bucks and do rated power.

they will be in mine. tell em i said i hope everything works out well for them

if u plan on having the tahoe for a while, i would go with the 18, u could always sell it later and buy a 15.

good deal