pimpedout97x

ill measure the room in a few, but its wired for 7.1 and thats what he wants...lol also, the front 2 channels arent on the wall, the wires are by the base boards, so the fronts need to be towers. the side and rear speakers are mounted on the top of the walls, close to the ceiling.

haha yea i love my garage

got these things really mounted good now. need to brace it a little more, before i fleece it to the stock door panel all around the edges

jake, thats the 3000d i bought from Joey yesterday, btw

total so far is 2x 3000ds and 2x 100.2s gotta pre order my 100.4

ill snap some pics later

any bullet/horn tweeter is loud as hell. lol

bastard, i just bought 2 brand new 100.2s for 380 shipped, 40 more bux and i coulda had these!

Ill vote for that one

poo

get a d2 so you dont have to bother with .5 ohm. no need to, 1 ohm is fine

should be good. do you already have the sub? if not, try and get d2 so you can just run the amp at 1 ohm. that amp @ 1 ohm will be PLENTY for that sub, and will be easier on your electrical.

id say at least 2 bigger batteries.

id assume yes.. lol

sundown ia 20.1 etc

i want the first pair of 18s!

lol, yes having a wee bit of a problem though, with getting all the mids to fit in my door, without a few of them hitting the seat.

lol @ 5 hour energy shot hahaha nice set up though!

jake- what is the cutout dimension on these? my selenium 6.5" mids are going to have a hard time fitting in my door panels the way i want...these would give me an extra .7125" of clearance over the seleniums.

nice

thats what im leaning at, and running a 100.4 @ 3 ohms per channel, keeping the gains low, i'd say roughly 30w+ each. the 50.4 would prally be not enough power, or should i run that? (again, at 3 ohms per channel) what do you think the 100.4/50.4 would put out at 3 ohms/ch?

keeps raining on and off..pissing me off anyways i made the amp rack for the 100.2s. i could have just screwed them to the front of the wall, but i wanted to make an amp rack for them that will be covered in suede, accenting the walls trim panel which will be vinyl plenty of room the little notch in the center where it looks like i hacked at the wood is becuase my center console cupholder wouldnt clear it unless i did that this is my rear hatch emergency release, currently the ONLY way to access the trunk lol...im gonna tech-flex over that wire to make it look nicer, and i have that little grommet to go in that hole. why i had to notch the amprack in the middle filled some spots in the port...will re paint it soon