emh9009

Very nice! Can't wait for some SSA gear to show people up with!

what setting did you use? try switching + and - too see if its out of phase by chance?

For a daily box 30-35 seems to be the preferred choice. I"m happy with my 35 hz tuning!

Even climate control in the glove box! Pretty damn smooth.

Going to get this album, for sure!

I've tried 2 lines of Fi. Really want to try some SSA Back window is a bitch, and the rear defogger doesn't work. Still haven't figured out why... haven't put much time into it either haha

I've never seen flex like that from outside, I'm always inside! haha Next subs with either be Fcons or SSDs

Gave a demo, another guy took a little video.

I'd buy one for my girl

Looks like you have jell-o hands! Why no gaskets?

Ordered 3 batteries from Ram. Received them in a timely manor, packaged well. Great prices and a helpful guy to deal with. For Ryan.

sorry I get to chattin' and clog up the thread It's dumping buckets of rain out right now.. Kinda' sucks. Yeah, understandable. The only part I'm caught up on is where to put the leads from my front battery. I think I have them in the best place possible, and it seems that's what everyone is agreeing on. I just need to go to the home depot and get a board to make a new beauty panel and some bolts for the new batteries and get to work!

If you normally wear a med. and order a large then it's going to be large on you.

Rebuild!

I've read that having the ground have to go through all the aluminum and welds and such in my car to get to the front - isn't the best. And I already have the wire, so why not?

Do I have it correct in my diagram? I'm not worried about audible differences, just don't want to have really uneven power distribution.

Those are some sweet ass lookin mids! Why did you choose tweets on bottom? mounting depth?

Very nice! props on the pods! I like the setup

But the site with the diagrams that has been linked said to take them from opposite ends for better distribution of electrical load?

Why not? mount the Xover by the mids, run tweeter wires to the front. Not difficult at all.

That's the crossover. And no, it doesn't. But you will need to have the ability to set the crossover points for the 6.5 on either your amp or HU. Why don't you want to use it?

The old tweeter spot was up on the dash, is that what you mean? Yeah