drgnhurt

Between these two amps, PG Octane-R (4 channel)series and Hifonics Titan (4 channel)Series, which one will you choose???...

Im looking at these 2 amps to power my 12" polk sub(150WRMS) and my front SEPS. Would you guys know which one is better in terms of quality and performance?... just base your answer with your experience and the brand name, just in case you have'nt listen or audition this models.. its not available locally so im asking the experts on AMPS... they are both on the same price range in Ebay, shipped. Im leaning to power acoustik bcoz it has more power than PG though im not sure if it is over rated... But most of the people in other forums recommend PG.... so that's make me confused... so pls help me to decide guys... many thanks... POWER ACOUSTIK OV4 800 * PWM Mosfet Power Supply * Variable Low-Pass and High-Pass Crossovers * Defeatable Bass Boost at 45 Hz * Tri-Mode Capable * 3-Way Protection Circuit * Gold-Plated Input Terminals * RCA Outputs * RMS Power @ 4 Ohms: 85W x 4 * THD at 4-Ohm RMS Power: 0.02% * Bridged RMS Power @ 4 Ohms: 210W x 2 * Speaker Level Inputs: Yes * Preamp Outputs: Yes * Built-In Crossovers: HP/LP * Bass Boost: 18 dB * Frequency Response: 10-30,000 Hz * Signal to Noise Ratio: 97 dB PHOENIX GOLD OCTANE -R5.0.4 * Independent front and rear adjustable input sensitivity controls * Adjustable 0

What is the best entry level amp in the market today?... Obviously they will not match those high-end amp so lets not compare them... just want to know for consumer preference...

multi channel with a price range of $100-150++ with at least 200-300WRMS(not peak power)

by the way, how can you be so sure that PA make Octane AMPs while PA amps were made in Korea and PG is in China?... can you clarufy this?.. thanks

so u mean PA makes this Octane-R amps if that the case i'll go with PA coz they are more cheaper with more power than PG... or what would you suggest?.. should i stick to PG?... what about audiobahn?..

Can a 150WRMS output from the AMP is enough to boost a 175WRMS Sub?.. Will it sound good?... what would you recommend if that is the scenario to improved performance of the sub or the amp considering that's gonna be the setup?.. thanks

i have the polk audio gnx124,12", 175-400 watts RMS, SVC, 4 ohms and im thinking of getting the PG Octane R5.0.4 to power this, its a 200WRMS in 4 channel so 2 channel bridge will put out 150 watts of RMS in 4 ohms im just a newbie... and just building up a new entry-level system thanks for the reply by the way...