mikel7829

How much memory do you have installed? what OS,and how many slots available for use?3 slots, 6gb in 2 slots, Windows 7 64I would try changing slots I have seen faulty memory banks on motherboards....And remove a stick of DDR and try to boot, 3 gigs should be able to boot windows 7 what banks are the DDR installed in? And what model motherboard are you using?Michael Well I would but...After trying to run 3Dmark yesterday it won't boot. I can get it into Bios or Safe mode just fine. Figured that 3D Mark overheated and mulched the video card. Went downstairs to see if the fan was spinning....can't see shit so I touched it and burnt my finger. If I go into safe mode and uninstall the video card driver will it use the equivalent that it uses in safe mode to boot into windows? Figure that would confirm my suspicion if I am not nuts. If that is the case I need a video card. Photo editing, internet and some word processing so nothing major but I don't want it laggy. I would pay extra for a video card that had dual HDMI outputs in particular if they could run at different resolutions. I need 1920x1200 and 1920x1080 at the same time if at all possible. And don't forget to go into regedit and delete any registry entries from your ATI software,drivers ect.before you load your new graphics card software...I would check out som nvida based cards at newegg they have some good deals!http://www.newegg.com/Product/ProductList.aspx?Submit=ENE&IsNodeId=1&N=100007709 600030348 can't I just remove the hardware in safe mode? I think your smarter than this Sean My honest opinion what I would do would be to visit western digital or seagate's website and get me some free H/D tools and low level format my drives that will re-write every sector back to 0 "factory state".. That fat32 or ntfs will not on you windows cd,, And flash your bios firmware interface revision that will re-write anything that may have targeted your bios cache...if you are unsure this is a shit video card or fan issue.. Only thing else I can think of I have no fuckin clue else!

How much memory do you have installed? what OS,and how many slots available for use?3 slots, 6gb in 2 slots, Windows 7 64I would try changing slots I have seen faulty memory banks on motherboards....And remove a stick of DDR and try to boot, 3 gigs should be able to boot windows 7 what banks are the DDR installed in? And what model motherboard are you using?Michael Well I would but...After trying to run 3Dmark yesterday it won't boot. I can get it into Bios or Safe mode just fine. Figured that 3D Mark overheated and mulched the video card. Went downstairs to see if the fan was spinning....can't see shit so I touched it and burnt my finger. If I go into safe mode and uninstall the video card driver will it use the equivalent that it uses in safe mode to boot into windows? Figure that would confirm my suspicion if I am not nuts. If that is the case I need a video card. Photo editing, internet and some word processing so nothing major but I don't want it laggy. I would pay extra for a video card that had dual HDMI outputs in particular if they could run at different resolutions. I need 1920x1200 and 1920x1080 at the same time if at all possible. And don't forget to go into regedit and delete any registry entries from your ATI software,drivers ect.before you load your new graphics card software...I would check out som nvida based cards at newegg they have some good deals!http://www.newegg.com/Product/ProductList.aspx?Submit=ENE&IsNodeId=1&N=100007709 600030348 can't I just remove the hardware in safe mode? Do you have a copy of windows 7?

do you have a deep fryer? Not no more I am really trying to stay away from the deep fried foods. But I love deep fried mushrooms,and deep fried corn on the cob

Old skool 2xDVI... But one thing about BFG is you can send for a replacement "lifetime warranty ..if the model is discontinued you can get it replace with the next best model..nothing wrong with this it was a beast in it's day!! One of my favorite cards back in the day probably.. ">http:// ">http:// ">http:// ">http://http://s1293.photobucket.com/user/mikel7829/media/20150212_190054_zps10kkjfsl.jpg.html'>

How much memory do you have installed? what OS,and how many slots available for use? 3 slots, 6gb in 2 slots, Windows 7 64 I would try changing slots I have seen faulty memory banks on motherboards....And remove a stick of DDR and try to boot, 3 gigs should be able to boot windows 7 what banks are the DDR installed in? And what model motherboard are you using? Michael Well I would but...After trying to run 3Dmark yesterday it won't boot. I can get it into Bios or Safe mode just fine. Figured that 3D Mark overheated and mulched the video card. Went downstairs to see if the fan was spinning....can't see shit so I touched it and burnt my finger. If I go into safe mode and uninstall the video card driver will it use the equivalent that it uses in safe mode to boot into windows? Figure that would confirm my suspicion if I am not nuts. If that is the case I need a video card. Photo editing, internet and some word processing so nothing major but I don't want it laggy. I would pay extra for a video card that had dual HDMI outputs in particular if they could run at different resolutions. I need 1920x1200 and 1920x1080 at the same time if at all possible. And don't forget to go into regedit and delete any registry entries from your ATI software,drivers ect.before you load your new graphics card software...I would check out som nvida based cards at newegg they have some good deals! http://www.newegg.com/Product/ProductList.aspx?Submit=ENE&IsNodeId=1&N=100007709 600030348

Or some good homemade hot wings..Any suggestions?

That is hard to screw up....although most I've had is screwed up. You have me craving some ribs now

How much memory do you have installed? what OS,and how many slots available for use? 3 slots, 6gb in 2 slots, Windows 7 64 I would try changing slots I have seen faulty memory banks on motherboards....And remove a stick of DDR and try to boot, 3 gigs should be able to boot windows 7 what banks are the DDR installed in? And what model motherboard are you using? Michael Well I would but...After trying to run 3Dmark yesterday it won't boot. I can get it into Bios or Safe mode just fine. Figured that 3D Mark overheated and mulched the video card. Went downstairs to see if the fan was spinning....can't see shit so I touched it and burnt my finger. If I go into safe mode and uninstall the video card driver will it use the equivalent that it uses in safe mode to boot into windows? Figure that would confirm my suspicion if I am not nuts. If that is the case I need a video card. Photo editing, internet and some word processing so nothing major but I don't want it laggy. I would pay extra for a video card that had dual HDMI outputs in particular if they could run at different resolutions. I need 1920x1200 and 1920x1080 at the same time if at all possible. in safe mode will have reduced functionality, but the task of isolating problems is easier because many non-core components are disabled.As your said video card and the function of the the graphics card double data rate function ability.. So yes in safe mode you will be using very limited microsoft drivers..And true enough I would for sure check on your driver version if you are using a ati base chipset video card!! Great graphics but their driver software is not very user friendly That is why I like the nvida chipsets...more user friendly..

Another dish from the 1/2 cow.....Tip roast ">http:// ">http:// ">http:// ">http://http://s1293.photobucket.com/user/mikel7829/media/20150211_1641151_zpszagy6p5v.jpg.html'> 2 more hours maybe and I am fixing to get my grub on!!

How much memory do you have installed? what OS,and how many slots available for use? 3 slots, 6gb in 2 slots, Windows 7 64 I would try changing slots I have seen faulty memory banks on motherboards....And remove a stick of DDR and try to boot, 3 gigs should be able to boot windows 7 what banks are the DDR installed in? And what model motherboard are you using? Michael

$300.00 for a bank?

I have a XS Power D925 ordered..And have done a 2/0 big three upgrade..Would this be efficient you think? Thanks, Michael

On a SQ-3500D.1 @ 4300rms at 14.4 how many banks do you think I would need to maintain a decent voltage with a mechman 320 amp? Thanks, Michael

How much memory do you have installed? what OS,and how many slots available for use?

which ones?Maxwell's for for around 125-200 depending. The greens one like mine are 300 per bank New Were did you order these from?

I need to fire up the air compressor and blow them out a bit were they have been setting while I have time..Took a vacation day Some of them have acquired some mean dust bunnies Aaron

Take them like your suppose to...Not eat them like skittles... Doppie 10mg does nothing but make me mildy feel ok. 20mg is like coffee to everyone else. I get a boost of energy. 30mg starts to help revs me up like a stimulant but I'm high and still only marginally pain free. 40mg I'm stoned hard and just stop caring that I hurt. I'm awake like nothing else but deal with waves of being only able to listen to music. Coltrane or Mingus please. Green 80 oc's?

Try removing a ddr stick at a time.....and test.. my guess is a foul stick of memory..idk

Man only if you knew Sean...You haven't seen shit!!

Take them like your suppose to...Not eat them like skittles...But opiates are so much fun when you take lots of them. I guess...Is it fun when your spending all you monies on them and cant get out of bed

Take them like your suppose to...Not eat them like skittles... Doppie

This is just part of the horse stable....I have including this 5 out buildings full of shit...I have a boatload of vintage to not so old PC's electronics is my hobby ">http:// ">http:// ">http:// ">http:// ">http://http://s1293.photobucket.com/user/mikel7829/media/20150210_200526_zpsbjzsdcqd.jpg.html'> I have a shit load more...probably about 75 PC's at least

Or you can re-route your current feed if your handy with a solder gun..and get a longer path for your voltage supply to said chipset to raise resistance that will lower voltage..

All else fails I have a 9500gt you can get..Old but it works but has had a history of being overclocked