Julian

Cone area is king. I see you're from St Joe. I used to work at NW audio, if you need advice that's an excellent shop to go to. They know their stuff especially for SPL.

one or two group 31's or one g31 and a fairly large output alt.

what make year and model? also what steering wheel module? 01 buick century. i'll be doing a tablet install and i have a unit that taps of the steering wheel controls. Basic wiring colors And this is what the ASWC-1 uses for data for the steering wheel controls http://contentdocs.installernet.com/documents/vehicle/12434.pdf

poast

what make year and model? also what steering wheel module?

We've had 3 psi recones go mysteriously soft to the point where you could bottom them out with your hand. One coil go mysteriously bad. So I tend to say no to psi.

I'm in Monterey my self

Where at in norcal?

is that the tantric stuff?

my first mech mod

' Taking the sled out eh Sean?

If your paint on the outside isn't great you can use dry ice on the top to make it brittle and scrape it off.

Yeah toluene and a hard plastic scraper would probably work. In order of decreasing speed (i.e., fastest first): acetonenapthapaint thinnerkerosene, diesel Gasoline works too but I wouldn't want my car reeking of gas lol

I had the SD2.0 the older model to the HDS212 in a 4 cube box tuned to 28ish hz and it got down pretty good in the mustang with a 6" port. But they lasted a whole week before the coils delaminated and started rattling.

The stingers are my personal favorite

nEED IT BAD.... hURRY hURRY.No need to yell this isn't boot camp

We get some pretty great local crab around here but it's only the pricey size.

Sigh

Voice coils wired in parallel, speakers wired in series and then the pair of 4 wired in parallel for a final 4 ohm loadHow would that look? The same as series parallel It would look exactly like that 2 sets of 4 wired in parallel (black to black red to red) of the end of the chain.

Voice coils wired in parallel, speakers wired in series and then the pair of 4 wired in parallel for a final 4 ohm load

(series/parallel) on the first 4 then wire the sets of 4 together in parallel getting you to a final load of 2 ohms. Or run them all parallel for a total of .5 ohms.

Pretty much what cloud said. There can be a pretty noticeable dim even with big electrical just due to how little difference it takes to be noticeable, if it's really that bad.

Same Shit different asshole

We eat a lot since it's a cheap, quick, and healthy protein that can be thrown in a lot of different dishes. Plus the fact they freeze pretty well means we always have some.