Julian

no prob

that actually sounds like a good plan to me. or you could get something like this My link and then switch the terminals out each time you want to take the battery out because it would go fuse block, battery, amp. any ways so all you would have to do is that.

i wired mine to my HU for me the voltage difference was a little over a tenth of a volt between the front and the rear. so just test it out and see if it differs that much, no need to run a huge run of wire for no reason

well you have to measure your maximum dimensions for us to have ANY idea. Also, any electrical upgrades, budget constraints?, amplifiers, etc. without any information we can't help you.

the kicker amps are only able to godown to 2 ohms i believe

google is your FRIEND

if a JL could talk, thats how that w7 would talk.

you won't need a "distro" you'll need splitters of some kind

the driver allows you to tune lower, the box would be most important in this case. Yes, but in reference to what he's asking, it's not driver specific. yeah but you mentioned install and vehicle will determine everything which is of course false information. the box would be more important than any of those in terms of hittin lows. The enclosure is part of the install, no? nope. the enclosure is the enclosure. do you just install the box, no you design it and then build it. it would be part of an install if it was a premade box. And how is the box not part of the actual install ? Are you towing the box behind the vehicle ? You have some very skewed ideas.... so your saying nothing is specific....... everything that goes in is called an install. so it doesnt matter what sub, electrical, amp, box, tuning is all generalized by install because they are all being installed. lol Stealth, in general your opinion doesn't matter, at all. You've been consistently wrong on the MOST basic ideas. I think (and im not the only one) you need to stop being the know it all arseho (with indeed the wrong information) and listen for a change. The enclosure is part of the install, the peak frequency of your car changes everything, example; my box was tuned to 32hz i peaked at 38hz. simple You sir, are an idiot.

fix my speaker.com is Dave from PSI, talk to him see what he says, it's probably a no. but its worth a try.

you can run ipod through 2.5mm headphone jack they're cheap, and if you have an ipod why cds? and am/fm most stereos will play.

expect rated at 12v with a littlebit more at 12+v

I would go with Db-R great work, reliable, they put up with constant updates , and they're CS is amazing to say the least.

Warm is okay, now hot is a problem my 3000d ran warm but was never a problem

Actually 13.2 is pretty good actually very good at full tilt

I think it was Thumper said that Exile is from the old guys at PG and it's a good amplifier.

I would love to try stetsom amps, how are they? how do they compare to other brands? i want to get a 7kd.

New Jersey right?!

Small is correct some caulking will eat the surround of foam I think it's mostly with the silacone. But airing the enclosure while it dries for the full reccomened time. After that it is perfectly good to use as long as it's cured.

If I were you I'd find some used tc's or audiopulses. Great products. Give ssa a look too the xcons are great sealed or ported

Scion tc's run pretty cheap, they get hella loud too.

Vibe is from europe, Ive heard some good reviews from Mark

I had a Chevy Lumina and the Impala's, and monte's all have the same style trunk i was able to fit 3.5 cuft without chocking my 15" if iwas him i'd either look into two twelves or 1 15"

SPY always makes beautiful looking boxes.

I wouldn't say ported are one note enclosures. My 15 was very dynamic, it picked up the lows and the highs quite well. They're much more efficient than sealed. I would always choose a ported box over a sealed. "All thread" rods are fantastic for bracing, very tough (they're basically a long steel bolt but it's all thread) They take up minimal space, if i were you i'd do Double baffle and use All Thread for bracing. One from the baffle to the back of the box and one vertically. I really hope you port those Titanium elites. They have a ton of Xmax and should excel in a ported enclosure.