crownvicon24's

I'm going to replace my redtop. I have two batteries in mind that I can get at a really good price, a Kinetik hc1800 and a Deka Intimidator. Which do you think I should get?

yeah im definetly going to get the deka now. i found one for $50 local. im going to get it in the morning.

yeah im definetly going to get the deka now. i found one for $50 local. im going to get it in the morning.

I know I was looking at the sax 50.4. I think this amp will fit my needs, but im not ready to buy another mid amp yet. Im still trying to get my electrical straighted out. I know the sale will be over by the time I get this situated so I will probably have to try and find one used.

I plan on running 2 more speakers im going to put 2 more 5 1/4'' s in my rear doors for a total of 8 speakers. I would like to send about 50 watts to each speaker so I need 100 X 4 @ 2 ohms per channel. Im not too familiar with Sundown amps would a sax 50.4 give me this amount of power @ 2 ohms?

Either way it wont matter since you will be giving both speakers the same power either way, usually it would matter if you run them at 1 ohm or 2 ohms (since a lower ohm load = equals lower power and less strain on the vehicles voltage) but in this case you will be bridging at its ohm load stability also so I think it will be an even call. It just boils down to personal preference. Sorry jay-cee your incorrect. lower ohm load = a higher strain on your electrical system. you loose efficiency as the ohm load goes down there fore your amplifier requires more amperage. Its solely dependent on the amp if you can run it at .5ohms some can some cant. In my opinion i wouldn't run an amp below rated specs unless your aware of the the harm you can do and willing to live with the out come. For a daily situation you'll be far better off at 1ohm and that would be the best advice i can give you. I meant either way he wired the subs up 1600 x 2 @ 1ohm or 3200 x 1 @ 1ohm it would be the same, I didnt even answer the question about wiring it for .5 ohm load, I only did that too one amp (memphis power reference 1000.1 just to see how long it would last for and it did for almost a year) and I didnt even know thats how I let a local shop do it awhile back. Vowed to never let them do my work again, but I would never recommend anybody to run a amp below its ohm stability unless you wanna kill your amp eventually and cause a lot of strain on your electrical. That amp is a two channel amp. It can handle 1600 X 2 @ 1ohm, 3200 X 1 @ 2 ohms but not 3200 X 1 @ 1 ohm.

I would do the tens.

To OP I had my rear batts out until I waited for a new one and my voltage dropped to the mid to low 12's with a 200 amp alt , redtop batt, and big 3 in 1/0, with 2000 watts. I think you will need atleast a hc1800 in the trunk. I had a hc800 and a spv35 in my trunk and dropped to around 13. 3 full tilt. I would recommend a bigger battery in the back. If your running different kinds of batts. I have a 200 amp stinger isolator that will keep these batteries seperated for $25 shipped.

Just want to say hi to everyone as you can see im new just trying to make my self at home.

Wzup guys! Thank for THE welcome.

wzup. heard I would be hearing from ya. I need my drink. BTW I want to touchem too.

Yeah OP sorry for the thread jack. Clean azz lincoln man. Setup looks loud. Got any #'s? You have a really stable electrical. Cant believe it stays @ 13.6 at full tilt. Thats amazing! I will have some pics and vids soon. Took my wheels off for the winter. About to get it painted and do my interior. I will post when im done.

ok. Doing it right now.

Didn't know about them banning people. Yeah allot of the guy over there really dont know what they are talking about or have bad attitudes thats why I regestered here. Only pics I have are of my old setup. I will take and post some of my new one soon. How do I make and put vids on here never done that before?

Nah I haven't been banned just looking for a change. Figure this forum would be a lil more mature.

Thanks. I need one.

Wzup man. Yeah im from the CA forum. Im in S.C. I dont like all of the immature post on the CA forum. You cant even ask a question on there without them giving you a smart remark. I know a little but there are people out there that are learning and if they ask a question they get flamed. How did you know I was from CA? Killer setup btw.

hey welocome. I see your system is already gangster ..so what power you bring here? ?

I would get the 2608d. It will give you atleast 2000 watts @ 1 ohm.

Thanks.Nice to meet you guys.