johnecon2001

That noise sounds like I'm 5 years old again and beating on my moms cookie sheets

I don't know how Debt free feels (almost there), but I bet it feels great! I said yes, but i'll tack this on the back end.. Only if you can do it with out going back into debt.

Scott is who you want.

This was a little different man. You can't see what I can.

damn its been a week all ready and i haven't received nothing It's Monday.

Keep it on topic folks.

I can't WAIT to see how you're going to wire these to the amps

There are an awful lot of nice subs for under $350. I know the W7 is a beast, but I'm a cheap bastard and would never pay quite that much for a driver that plays 1/8th of the total frequencies in my car.

Herro! I couldn't find your old account either, so welcome back!

As far as I remember, the Daytona series is the only one that does rated+ power. The ZRS puts out rated power under nominal circumstances.. but when does that happen in a car?

That looks old enough to be pre-radio crap

In a sealed or ported box? How much power? Which Sub? What altitude? What electrical system? How many volts on your HU? What car? What kind of wood will the box be built with? Will you fiberglass the inside? Carpet the outside? What temperature will the air be? Will the amp be ran in a cool environment. Until you can answer all of those questions and MORE, there is no way to tell you which will be better. It really comes down to what you can FIT.

Better for what?

It's an SPL sub... You seal it.. I'ma keel you.

http://www.soundsolutionsaudio.com/shop/in...at&catId=54

You may as well install the 180a one you have now to see if it cuts the mustard. No sense in upgrading if what you already have will do the job for you. If it doesn't do what you want it to, then upgrade to something substantially larger (240a+).

You could always whip out a handy tape measure and go nuts. And amplifier doesn't really mean squat as far as deadening goes. Many more factors to consider before telling someone to do 3 layers based off of using one SAZ-3000D.

Woah.. What plate amp?

The Q and the Havoc are the same woofer (the Havoc has a different dust cap and the copper coil option standard). If you're gonna wall it off, do either the Q or the Havoc. And tune down low. Anywhere from 28-32hz would be perfect. Or you could do 4 15's sealed and get the entire frequency spectrum.

You tease! I see no bikini's!

http://www.soundsolutionsaudio.com/forum/i...showtopic=14799 http://www.soundsolutionsaudio.com/forum/i...showtopic=14797