ANeonRider

Seas CA18RLY or RNX dependant on depth http://www.madisound.com/catalog/product_i...products_id=789 http://www.madisound.com/catalog/product_i...products_id=823 Tweeters: http://www.madisound.com/catalog/product_i...products_id=543 http://www.madisound.com/catalog/product_i...products_id=633 http://www.madisound.com/catalog/product_i...roducts_id=1466 Or, if you want to do something different for the higher frequencies... http://www.madisound.com/catalog/product_i...;products_id=85 What vehicle?

Even if you grab some protein powder, milk & oatmeal, and blend them up.... that would be a good breakfast. Good carbs, protein & a small amount of fat to start the day. My ideal (which I rarely have time for) breakfast is 3 whole eggs & a bowl of oatmeal with a glass of skim milk.

Depth available for the mid?

http://www.sounddeadenershowdown.com/

Weighed in at 220 this morning. Down 24 pounds now.

The Sundown 100.4 can be used to crossover actively. Willing to do that?

It will make it hotter because more W created = more heat created as part of the process.

Couldn't take it anymore: http://www.soundsolutionsaudio.com/forum/i...ic=9608&hl=

Are you done fucking the vented pole of the Fi BTL yet?

If you have a sub that has an impedance of 4 ohms, and an amp that outputs 1000WRMS at 1 ohm, you won't be getting 1000W @ 4 ohms unless the amplifier output is regulated....

Never used myspace... tried, but it is such a shitty user interface. Facebook on the other hand... Add me.. [email protected]

http://www.diysubwoofers.org/misc/portcal.htm

Nope, mach5audio mli-65

new? new = $$$$$ and lots of it.

I'm going to have to write a tutorial on how to set gains with a scope soon here...

Both would get the job done... but the second one would probably be easier to use & lighter. Tektronix is the brand I used in school, and use at work.

Top

lol, caught.

That's your inexperienced opinion. Any o-scope will work, its audio band AC anyways. Find whats cheap, link it here, I, or someone else will let ya know yay or nay

I have run 3 of them, in parallel (0.67 load) off of a XT2000d, sealed. I wouldn't power them more than that.

It is about 2.3-2.4 or so. A touch smaller than I would have liked.

It will make sound... but crossovers are designed for each driver's characteristics. That being said, the crossover points will not be the same as it would be with the original equipment. Would I do it? No. Have I done it for others? Yes, as a temporary fix until I could do something active, or design & build a correct passive crossover.

Pipe organ

Wow, one thread not enough?

Only reason I can see for dual tweets would be a tweet in the kicks playing the full signal strength, and another smaller tweet in the a-pillar that is attenuated like 6dB & playing 10k & higher to bring the stage height up.