ANeonRider

Topidiots.

Stupid event on Facebook: Buy Nothing Day November 23rd. Ok, so I'll buy everything on the days before & after, and make no point at all. Dummies.

This technology isn't limited to subwoofers

hmm, my 3 way cost: Peerless = $160 NS3 = $40 XT19 = $40 So, 240 total. My processor cost $500, but I could have went with something MUCH cheaper if I needed to.

New Update & pictures in the project log

Agreed, the Rockies... rock. Although I really do love the forest & lakes here in the north. I came from the south part of the province, where there are no trees. Something can be said about the sunsets down there though, out in the middle of the prairie/pasture land & you are really the only human for miles & miles. Cypress Hills is an anomoly though lol.

lol, no crap. Basically the whole area north of Prince Albert here in Saskactchewan is a big, deep lake cut out of the rock & it all drains through Manitoba.

"compression" format that is not lossy, in other words, does not remove any information from the source.

No... sounds like the passive crossover is blown.

delaytop

haha, well, all for not now if they don't get back up

I had some decent space to use too... 1.5 share ratio. My ratio was fine (never below 1.3) but my buffer was quite large...I could have downloaded another 230GB without uploading anything before I would have been banned. I only had ~80GB of room to mess with

I had some decent space to use too... 1.5 share ratio.

http://www.telegraph.co.uk/connected/main....download123.xml Interpol shut them down. They'll be back, just when?

I'd use them sealed....

Only Alpine headunits that have the Bass Engine Pro feature can be used for a 2 way + sub active system. There are others, I just can't remember them all.

LOL, nice. Just take the back seat out of your car and fit them in that way. Can't... have a baffle in the way lol.

I wasn't thinking ahead very well... my towers are 6ft tall, and I cannot fit them in my car to get them home. LOL Guess I'm going to have to bug a friend with a truck or SUV to give me a hand.

Montreal is where its at.

Mine can.

Which ripper did you go to?

I pre-stuffed with this material: Did the whole length of the baffle & driver side of the port. Also used polyfill on the top of the driver side of the port. I'll see if my foresight works.

Done! Shitty cell phone picture, since I forgot the camera. Still have to do the long tedious task of finishing it. I used cat litter for ballast, left a cavity about 2.5" high on the bottom for it. Also used home audio grade bolts for my terminals LOL. I'll get to tower #2 some this week hopefully, but should be done by the end of next weekend.

I wouldn't use the SLS higher than 300Hz, lower still if possible.