ANeonRider

I think it goes like this, slide end of wire, insert wire into block, tighten end into block.

There won't be such a drastic impedance spike in sealed boxes.

Just got done my 4th interview in 2 days. I'm all interviewed out.

How do you know? You have never even touched either of them.

I don't build them (unless you want to pay the shipping from Canada ), but I do make plans for a sum.

meh, my little bro is a 6'5 260 lbs 15 year old. I havent grown an inch since I was 12, I'm 6'3

Sure do! Step into my office....

DMM = Digital Multimeter AND yes, a scope is the only way I would ever do it (and did )

Not to the precision you need to run that much power. Believe me, I know.

That works Thanks

Do you even know what impedance rise is? Really, you're not experienced enough to be playing the limits like that, and a DMM isn't going to help you overcome this.

Like you said yesterday, 1.5-2.5 ft^3 tuned to 28Hz. No rush either, I ran out of fibreglass matte, so I can't work on it anymore until I pick up some, and I don't have any time to do that until at least middle of next week.

Should work fine, I don't think any of the measurements are different, but worth the check. Also.. you will not be able to use a rear strut bar with the box. Be very careful with the gain on the Hifonics. You probably won't need a subsonic filter, unless you are going to be playing super subsonic frequencies (<20Hz).

In theory, Less surface area = Less friction = Less velocity loss = Less noise, more output. So... yes.

Yes, I've seen the ports on PE, but the problem is they don't come in long enough lengths, and I am leary of using aeroports because of the in-accurate tuning caused by the shape.

I'm with Supa. Nice box

They don't like them mainly because the market is dominated by pre-made unknown tuning frequency pieces of crap.

Even using a DMM, I would not risk it. O-Scope and impedance rise measurements are the only way to tell that it will be ok. Either way, I am not recommending it unless you know forsure what you are doing.

3mm of Xmax is negilible.

Have 3 interviews arranged for Monday. Good thing I'm so relaxed

Sure, go ahead, I don't have my computer with me so I can't do it for myself ATM The box size isn't definate yet, since it is going to be fibreglass, I will be measuring it after it is completed, probably using water.

I'm currently a bum looking for work, just finished my electronics engineering technologist degree last week. 4 interviews next week.

I am trying for 2ft^3 tuned to 28Hz ish.

Why does everyone have to live soooo far away. I want in on this little LMT party, but I really don't want to have this sub travel across the border ATM.